Results 151 to 160 of about 3,982,410 (283)

“More Than Just the Hip”: A Qualitative Study of Physiotherapists’ Experiences with Follow-Up of Frail Older Adults After Hip Fracture

Fysioterapeuten
Purpose: Norway has an aging population and an increasing prevalence of hip fractures, which is associated with high mortality rates. Rehabilitation guidelines for this patient group apply to specialist health services, and there is a lack of knowledge ...
Amalie Hempel, Ellen Dahl Gundersen
doaj  

Prediction of Surface Topography Parameters in Direct Laser Interference Patterning of Stainless Steel Using Infrared Monitoring and Convolutional Neural Networks

Advanced Engineering Materials, EarlyView.
This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky, Marcelo Sallese, Leander Kläber, Clemens Kuhn, Keming Du, Andrés Fabián Lasagni   +5 more
wiley   +1 more source

Zein‐Based Adhesives: Sustainable Extraction and Application in Bioadhesive Technologies

Advanced Engineering Materials, EarlyView.
Zein is extracted from corn gluten meal using a simple and scalable process with high yield (~90%). The resulting protein is applied in bioadhesives modified with Ca2+ and Fe3+ ions, exhibiting substrate‐dependent adhesion. The findings demonstrate competitive bonding performance and highlight the role of ionic interactions in tuning adhesion ...
Paula Bertolino Sanvezzo, Daniela Winsley Valereto Friozi, Vinícius de Oliveira, Marcia Cristina Branciforti   +3 more
wiley   +1 more source

A Revisit to a Qualitative Method for the Detection of Organophosphorus Pesticides. [PDF]

Indian J Clin Biochem, 2019
Chowdhary S, Banerjee D.
europepmc   +1 more source

Investigation of Laser Ablation and Brush Pre‐Treatments for AlCu Cold Roll Bonding in Oxygen‐Free Conditions

Advanced Engineering Materials, EarlyView.
It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti, Finn‐Lennard Janthur, Selina Raumel, Sascha Jan Zimmermann, Sarah Seffer, René Gustus, Sebastian Herbst, Marc C. Wurz, Ludger Overmeyer, Wolfgang Maus‐Friedrichs, Hans Jürgen Maier, Florian Nürnberger   +11 more
wiley   +1 more source

Microstructural Evolution and Vacancy Defect Formation in Mn–Mo–Ni RPV Steel Under Low Cycle Fatigue: Insights From EBSD and PALS

Advanced Engineering Materials, EarlyView.
Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar, Dhanadeep Dutta, G. Bharat Reddy   +2 more
wiley   +1 more source

Striving for purposeful autonomy: a qualitative method to enhance autonomy measurement in older adults. [PDF]

BMC Geriatr
Gobillot H, Genet B, Dieudonné B, Nicolas M, Haddad R, Boddaert J, Zerah L.   +6 more
europepmc   +1 more source

Characterization of Nitinol Produced by Laser Powder Bed Fusion for Mechanical Metamaterial Applications

Advanced Engineering Materials, EarlyView.
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek, Jakub Hurník, Miroslav Šmíd, Ondřej Zobač, Melanie Todt, Daniel Koutný   +5 more
wiley   +1 more source

'I had no choice!' Challenges in the informed consent and decision-making process for allogeneic stem cell transplantation: a qualitative method triangulation. [PDF]

Stem Cell Res Ther
Nowak A, Nadolny S, Jahn F, Schaffrath J, Müller LP, Schildmann J.   +5 more
europepmc   +1 more source

A Fast and Simple Qualitative Method for Screening Oleaginous Yeasts on Agar. [PDF]

J Lipids, 2018
Niehus X, Casas-Godoy L, Vargas-Sánchez M, Sandoval G.   +3 more
europepmc   +1 more source