Results 61 to 70 of about 10,013 (252)

Polymer Nanobridge On a Microfabricated Quartz Tuning Fork [PDF]

open access: yesECS Meeting Abstracts, 2013
Abstract not Available.
Sangmin Jeon, Seongjae Lee, Minhyuk Yun
openaire   +1 more source

Calibration of quartz tuning fork spring constants for non-contact atomic force microscopy: direct mechanical measurements and simulations

open access: yesBeilstein Journal of Nanotechnology, 2014
Quartz tuning forks are being increasingly employed as sensors in non-contact atomic force microscopy especially in the “qPlus” design. In this study a new and easily applicable setup has been used to determine the static spring constant at several ...
Jens Falter   +6 more
doaj   +1 more source

Influence of Air Pressure on the Resonance Properties of a T-Shaped Quartz Tuning Fork Coupled with Resonator Tubes

open access: yesApplied Sciences, 2021
A theoretical analysis and experimental investigation of the influence of gas pressure on resonance properties, namely, the quality factor and resonance frequency, of a T-shaped quartz tuning fork (QTF) is reported here. Two configurations are considered:
Mariagrazia Olivieri   +9 more
doaj   +1 more source

Quartz Tuning Fork as in-situ Sensor of Bacterial Biofilm

open access: yesProcedia Engineering, 2014
AbstractPiezoelectric Quartz Tuning Forks (QTFs) were used as a biofilm formation sensors. Modulated excitation technique allowed to measure the current generated by the QTF during the ringdown of the oscillations at conductive environments such as a liquid culture growth medium.
Piasecki, Tomasz   +4 more
openaire   +1 more source

Spring constant of a tuning-fork sensor for dynamic force microscopy

open access: yesBeilstein Journal of Nanotechnology, 2012
We present an overview of experimental and numerical methods to determine the spring constant of a quartz tuning fork in qPlus configuration. The simple calculation for a rectangular cantilever is compared to the values obtained by the analysis of the ...
Dennis van Vörden   +4 more
doaj   +1 more source

Development of Self-Vibration and -Detection AFM Probe by using Quartz Tuning Fork [PDF]

open access: yes, 2007
We developed a novel type of quartz tuning-fork probe that vibrates and detects its own probe deformation, for application to atomic force microscopy (AFM).
Sato, K.   +17 more
core   +1 more source

Quartz tuning-fork type AFM probe operated in Anti-phase Vibration Mode [PDF]

open access: yes, 2006
This paper presents that quartz tuning fork shows excellent properties as Atomic Force Microscopy (AFM) probe. We used Focused Ion Beam (FIB) system to monolithically form a sharp tip at the side end of one beam.
Sato, K.   +13 more
core   +1 more source

Fluid Sensing Using Quartz Tuning Forks—Measurement Technology and Applications

open access: yesSensors, 2019
We provide an overview of recent achievements using quartz tuning forks for sensing liquid viscosity and density. The benefits of using quartz crystal tuning forks (QTFs) over other sensors are discussed on the basis of physical arguments and issues arising in real world applications.
Thomas Voglhuber-Brunnmaier   +3 more
openaire   +4 more sources

Symmetrically arranged quartz tuning fork with soft cantilever for intermittent contact mode atomic force microscopy

open access: yes, 2003
The dynamic mode atomic force microscopy based on a microfabricated cantilever and a commercial quartz tuning fork was probed. The probe was self-sensing and self-actuating. The tuning fork performed the function of a force sensor.
Frederix, P.   +4 more
core   +2 more sources

Design, Development and Testing of Quartz Tuning Fork Temperature Sensor

open access: yes, 2011
In this paper, a low cost quartz tuning fork temperature sensor adopting H-shaped tuning fork resonator to address miniaturization, high resolution and high stability has been designed, developed and tested.
Jun Xu, Bo You, Jing Ma
core   +1 more source

Home - About - Disclaimer - Privacy