Results 121 to 130 of about 478,349 (287)

Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A

open access: yesAdvanced Engineering Materials, EarlyView.
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han   +5 more
wiley   +1 more source

Quenching for semidiscretizations of a semilinear heat equation with potential and general nonlinearity

open access: yesJournal of Numerical Analysis and Approximation Theory, 2011
This paper concerns the study of the numerical approximation for the following boundary value problem  \begin{equation*} \begin{cases} u_t(x,t)-u_{xx}(x,t)= -a(x)f(u(x,t)), & 00, \\ u(x,0)= u_{0}(x)>0, & 0\leq x \leq 1, \\ \end{cases} \end{equation*
Halima Nachid
doaj  

Enhanced Strength and Corrosion Resistance of Ti‐13Nb‐12Ta‐10Zr‐4Sn Alloy by Aging Treatment

open access: yesAdvanced Engineering Materials, EarlyView.
This work systematically investigates the effect of aging treatment on mechanical properties and corrosion behavior of vacuum arc‐melted Ti‐13Nb‐12Ta‐10Zr‐4Sn alloy. Owing to the increased α″ martensite, strength and corrosion resistance were significantly enhanced by aging treatment.
Yuhua Li   +5 more
wiley   +1 more source

Continuity of the quenching time in a semilinear heat equation with Neumann boundary condition

open access: yesJournal of Numerical Analysis and Approximation Theory, 2010
This paper concerns the study of a semilinear parabolic equation subject to Neumann boundary conditions and positive initial datum. Under some assumptions, we show that the solution of the above problem quenches in a finite time and estimate its ...
Firmin K. N'gohisse, Théodore K. Boni
doaj  

Evaluation of Plasticity and Creep Parameters From Tensile Stress–Strain Data for a Range of Strain Rates

open access: yesAdvanced Engineering Materials, EarlyView.
This plot compares experimental tensile stress–strain curves (with 4 different strain rates) and corresponding modelled curves (obtained using the optimised sets of Voce and Miller–Norton parameter values shown). The inferred M‐N values, characterizing the creep, are very similar to those obtained via conventional creep testing.
S. Ooi, R. P. Thompson, T. W. Clyne
wiley   +1 more source

In Situ Micromechanical Study of Bimodal γ′–γ″ Precipitate Assemblies in Ni–Cr–Al–Nb Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
A Ni–Cr–Al–Nb superalloy with a bimodal γ′–γ″ precipitate distribution is developed. Composite precipitate assemblies form through heterogeneous nucleation, effectively impeding dislocation motion. Micropillar compression reveals high strength at room and elevated temperatures, governed by precipitate shearing, with coupled faulting mechanisms ...
Ujjval Bansal   +4 more
wiley   +1 more source

The Quench Action

open access: yesJournal of Statistical Mechanics: Theory and Experiment, 2016
We give a pedagogical introduction to the methodology of the Quench Action, which is an effective representation for the calculation of time-dependent expectation values of physical operators following a generic out-of-equilibrium state preparation protocol (for example a quantum quench).
openaire   +3 more sources

In Situ Constructed Magnetic Core‐Shell Hydrogen‐Bonded Organic Framework‐on‐Metal–Organic Framework Structure: an Efficient Catalyst for Peroxymonosulfate Activation

open access: yesAdvanced Functional Materials, EarlyView.
In this work, a magnetic core‐shell catalyst (HOF‐on‐Fe3O4/ZIF‐67) is successfully synthesized, consisting of a metal–organic framework (ZIF‐67) with magnetic Fe3O4 as the core and a porous hydrogen‐bonded organic framework (HOF) as the shell. The catalyst efficiently activated peroxymonosulfate, resulting in rapid and effective removal of water ...
Yingying Du   +4 more
wiley   +1 more source

Holographic quantum quench

open access: yesJournal of Physics: Conference Series, 2012
Based on talks at 11th Workshop on Non-perturbative QCD (Paris, June 2011), Sixth Crete Regional Meeting on String Theory (Milos, June 2011) and Quantum Theory and Symmetries 7 (Prague, August 2011)
openaire   +2 more sources

Intermolecular Interactions as Driving Force of Increasing Multiphoton Absorption in a Perylene Diimide‐Based Coordination Polymer

open access: yesAdvanced Functional Materials, EarlyView.
This study uncovers the unexplored role of intermolecular interactions in multiphoton absorption in coordination polymers. By analyzing [Zn2tpda(DMA)2(DMF)0.3], it shows how the electronic coupling of the chromophores and confinement in the MOF enhance two‐and three‐photon absorption.
Simon Nicolas Deger   +11 more
wiley   +1 more source

Home - About - Disclaimer - Privacy