Results 31 to 40 of about 6,179,327 (244)
Terahertz Radar Cross Section Measurements Based on Millimeter-wave Converter
Leida xuebao, 2018 The measurement system has been built with Stepped Frequency Continuous Wave (SFCW) signal for Radar Cross Section (RCS) measurements in free-space at 220～330 GHz.
Wu Yang +3 more
doaj +1 more source
Radar Signatures of a Passenger Car [PDF]
, 2007 The upcoming new SAR satellites like TerraSAR-X and Radarsat-2 offer high spatial image resolution and dual receive antenna capabilities which open new opportunities for world-wide traffic monitoring applications.
Palubinskas, Gintautas, Runge, Hartmut
core +1 more source
Full Physics Simulation Study of Guardrail Radar-Returns for 77 GHz Automotive Radar Systems
IEEE Access, 2018 Radar is one of the primary active safety sensors for advanced driver assistance systems. Autonomous vehicles will heavily rely on the ability of automotive radar systems to accurately identify crucial targets while filtering out false targets.
Ushemadzoro Chipengo
doaj +1 more source
Calibration and Clutter Cancellation Techniques for Accurate Wideband Radar Cross Section Measurements [PDF]
, 2021 The expected received power is a key design parameter when designing a radar system. The radar’s receiver must be sensitive enough to detect the object of interest without being saturated by the highest received power. The object of interest’s visibility
Jarvis, Rachel
core
Advanced Engineering Materials, EarlyView.Sustainability assessment requires methodologies that appropriately distinguish between additive and non‐additive material properties. A toxicity‐weighted scoring system is developed and applied that accounts for the disproportionate influence of highly toxic constituents through nonlinear weighting functions, providing more realistic estimates than ...
Seth Mehalic +2 more
wiley +1 more source
Dual-Band Diffusive Metasurface-Based Reflector With Low Out-of-Band Backscattering
IEEE Access, 2020 This article describes a dual-band diffusive metasurface-based reflector, with a specular reflection band together with two sidebands which exhibit low radar cross-section (RCS).
Qihao Lv +5 more
doaj +1 more source
Advanced Functional Materials, EarlyView.Monolithic UV‐ozone oxidation of Ta forms an ultrathin Ta2O5/TaOx bilayer enabling resistive switching with a vertical defect gradient. A stoichiometric surface layer over an oxygen‐deficient sublayer promotes localized filament nucleation near the top interface, enabling low‐voltage operation, and reduced cycle‐to‐cycle variability.
Seunghoon Yang +11 more
wiley +1 more source
Polarimetric radar cross-section imaging
, 2017 The radar cross-section (RCS) is a fundamental quantity which determines if a radar target can be reliably detected by a radar system. This quantity can be modified by altering the shape of the target.
Dallmann, Thomas 1985- +1 more
core +2 more sources
Introducing Equivalent Radar Cross Section – A First Step Toward new Radiometric Requirement Definitions [PDF]
, 2014 Stringent radiometric SAR system requirements often significantly shape the design and cost of modern SAR systems. Yet the wording in current requirement documents is ambiguous, and a diligent conformance assessment at the end of project phases currently
Döring, Björn, Schwerdt, Marco
core
Bone‐Inspired Recyclable Composites for Damage‐Tolerant Circular Materials
Advanced Functional Materials, EarlyView.Bone‐inspired architected composites are developed by combining osteon‐like reinforcements with a recyclable Elium thermoplastic matrix. The hierarchical architecture redirects cracks and promotes energy dissipation, while enabling recovery of intact, aligned, load‐bearing reinforcement units that retain their original stiffness, revealing a route ...
Alessandro Stagni +4 more
wiley +1 more source