Results 31 to 40 of about 1,018 (216)
Applied Sciences, 2023 This work evaluates the feasibility of utilizing an organic Rankine cycle (ORC) for waste heat recovery in internal combustion engines to meet the stringent regulations for reducing emissions resulting from the combustion of fossil fuels.
Fuhaid Alshammari +5 more
doaj +1 more source
Applied Sciences, 2018 An integrated design and optimization approach was developed for radial inflow turbines, which consists of two modules, an automated preliminary design module, and a flexible three-dimensional multidisciplinary optimization module.
Qinghua Deng +4 more
doaj +1 more source
Theoretical Prediction of Cavitation in Radial Inflow Turbines at Design and off-Design Conditions [PDF]
Engineering and Technology Journal, 2012 A theoretical method for the prediction of cavitation in hydraulic radial turbines is developed in this work. The method combines a steady, quasi-three dimensional analyses which are based on the streamline curvature technique with an approach for the ...
Jafar M. Hassan, Mohammed I. Mohsin
doaj +1 more source
Analysis of Radial Inflow Turbine Losses Operating with Supercritical Carbon Dioxide
Energies, 2021 The losses of supercritical CO2 radial turbines with design power scales of about 1 MW were investigated by using computational fluid dynamic simulations. The simulation results were compared with loss predictions from enthalpy loss correlations. The aim
Antti Uusitalo, Aki Grönman
doaj +1 more source
Three Dimensional Flow in Radial-Inflow Turbines [PDF]
Volume 1: Turbomachinery, 1988 The flow through an impeller of a low speed radial-inflow turbine has been analysed using a fully three-dimensional viscous program and good correlations with instantaneous measurements of casing static pressure and exit flow distribution have been obtained.
M. Zangeneh-Kazemi +2 more
openaire +1 more source
Radial Inflow Turbine Meshing Rev. 1 [PDF]
, 2015 This report describes meshing utilities to support the mesh generation for Radial Inflow Turbines. This includes two tools: (a) parameterised mesh generator for Nozzle Guide Vanes; (b) a geometry and mesh generation tool for turbine rotors. A key feature
Jahn, Ingo
core +1 more source
Applied Sciences, 2018 This paper proposes an integrated design and optimization approach for radial inflow turbines consisting of an automated preliminary design module and a flexible three-dimensional multidisciplinary optimization module.
Qinghua Deng +4 more
doaj +1 more source
Data Reliability Enhancement for Wind-Turbine-Mounted Lidars
Remote Sensing, 2022 Wind lidars can be used on wind turbines to monitor the inflow for power curve verification and for control purposes. In these applications, the lidar is most often placed on the nacelle behind the rotating blades, which occasionally intercept the line ...
Nikolas Angelou, Mikael Sjöholm
doaj +1 more source
Characterisation of a 90° inflow radial turbine additively manufactured from Ti-6AL-4V [PDF]
MATEC Web of ConferencesAn experimental 90° inflow radial turbine was developed. Selective laser melting was used to manufacture three turbine rotors and three inlet guide vane assemblies. The turbines were manufactured from titanium alloy Ti-6Al-4V.
Cogho Max E., Jacobs Gysbert G.
doaj +1 more source
Radial Turbine Design for Solar Chimney Power Plants
Energies, 2021 Solar chimney power plants (SCPPs) collect air heated over a large area on the ground and exhaust it through a turbine or turbines located near the base of a tall chimney to produce renewable electricity.
Paul Caicedo, David Wood, Craig Johansen
doaj +1 more source