Results 231 to 240 of about 96,336 (267)

Stress analysis of ellipsoidal shell with radial nozzle

International Journal of Pressure Vessels and Piping, 1985
Abstract The thin shell equations of equilibrium in Love-Meissner form for an internally pressurized ellipsoidal vessel head with intersecting radial nozzle (flush or protruding) are solved numerically to obtain the stress distribution in both the ellipsoidal head and the nozzle. The results are presented graphically using appropriate non-dimensional
Y.J. Chao, M.A. Sutton
openaire   +1 more source

Stress changes of the distal radial growth plate

The American Journal of Sports Medicine, 1992
We conducted a radiographic survey to determine skel etal age and the nature and prevalence of stress-related changes affecting the distal radial growth plate in 60 young competitive gymnasts (39 females, 21 males). Comparison of results for chronological and skeletal age revealed a significant delay in maturation for girls (P < 0.001). Radiographic
D, Caine, S, Roy, K M, Singer, J, Broekhoff   +3 more
openaire   +2 more sources

The Stresses in a Flat Curved Bar Due to Concentrated Radial Loads

Journal of Applied Mechanics, 1952
Abstract This paper presents a Fourier integral solution for the plane-stress problem of a curved bar bounded by two concentric circles and loaded by any combination of radial loads on the circular boundaries. It is an extension of an earlier investigation (1) which dealt with only the particular case of a curved bar in equilibrium under
Nelson, C. W., Ancker, C. J. jun., Wu, Ning-Gau   +2 more
openaire   +2 more sources

Remodeling of the Radial Artery in Response to a Chronic Increase in Shear Stress

Hypertension, 1996
Abstract Chronic changes in large artery blood flow rates induce corresponding adjustments in arterial diameter, but little is known about structural adaptations of the vessel wall in humans. We used a high-resolution echo-tracking system to measure radial artery internal diameter, wall thickness, and mean blood flow on both ...
X, Girerd, G, London, P, Boutouyrie, J J, Mourad, M, Safar, S, Laurent   +5 more
openaire   +2 more sources

Measurement of the Stress Transmission Coefficient of Material Slugs in an Aerated Radial Stress Chamber

Particulate Science and Technology, 2003
In dense-phase pneumatic conveying, particles are transported along a pipeline at relatively low conveying speeds. Due to the relatively gentle handling characteristics of this mode of flow, it is suitable for conveying fragile and brittle bulk materials used in the food and chemical industries.
T. KRULL, M. G. JONES, A. W. ROBERTS, P. W. WYPYCH   +3 more
openaire   +1 more source

Effect of radial stress relaxation on fibre stress in filament winding of thick composites

Composites Manufacturing, 1995
Abstract During filament winding of thick cylinders, fibre wrinkling often occurs which severely decreases compressive strength. To eliminate fibre wrinkling, appropriate processing conditions must be found. Fibre migration and stress relaxation due to resin flow are generally considered the most important factors affecting fibre buckling. Therefore,
Evan A. Kempner, H.Thomas Hahn
openaire   +1 more source

Spinodal decomposition in a small radially stressed sphere

Acta Materialia, 2001
Abstract The conditions for thermodynamic equilibrium are derived for a binary alloy configured as a small sphere with radially symmetric composition and elastic fields. These conditions are used to test the stability of a homogeneous alloy against composition fluctuations and to write dynamical equations for microstructural evolution.
openaire   +1 more source

Radial stressing of thin sheets with plastic anisotropy

International Journal of Mechanical Sciences, 1986
The effect of transverse plastic orthotropy in uniform radial stressing at a circular hole, embedded in an infinite sheet, is studied. Material behaviour is modelled by a particular version of the anisotropic flow rule proposed by \textit{R. Hill} [Math. Proc. Cambridge Philos. Soc.
openaire   +2 more sources

Stresses and Strains of Radially Reinforced Hollow Cylinders

Journal of Engineering Mechanics, 1987
A radially reinforced hollow cylinder subjected to a combined action of axial pressure and radial pressures at both inside and outside radii is considered. These radial pressures are induced by hoop rebars. Due to uniform cross-sectional area of radial rebars, the reinforcement ratio is inversely propertional to the radius, and the cylinder is radially
openaire   +1 more source

Stresses in a circular disc containing a radial crack

2012
An analytic solution to a particular boundary value problem in linear elasticity is presented. The problem considered is that of a circular disc, in plane strain or generalized plane stress, which is loaded quite generally at the perimeter by a set of self equilibrating forces.
openaire   +1 more source