Results 171 to 180 of about 1,890,515 (294)
Arthritis Care &Research, EarlyView.Objective Despite well‐described biologic causes, the public views unhealthy lifestyle choices as the primary cause of gout. This study investigated how causal beliefs about gout influence the public's views about its management. Methods In a randomized study, 201 members of the public viewed one of two 2‐minute videos about gout.
Rachel Murdoch +6 more
wiley +1 more source
Structural length-scale sensitivities of reflectance measurements in continuous random media under the Born approximation. [PDF]
Opt Lett, 2012 Radosevich AJ +3 more
europepmc +1 more source
Arthritis Care &Research, EarlyView.Objective This study aimed to investigate hand function trajectories over five years in primary hand osteoarthritis (OA). Additionally, determinants of baseline and longitudinal hand function were assessed. Methods A total of 538 patients with both baseline and five‐year study visits were analyzed.
Annemiek V. E. M. Olde Meule +4 more
wiley +1 more source
Arthritis Care &Research, Accepted Article.Objective This study aimed to characterize cannabis product choices (cannabinoid content and formulation) among rheumatology patients, and their associations with patient factors, patient reported perceived side effects and positive impacts. Methods An online survey (delivered from March to November 2022) was distributed by Alberta Health Services to ...
Susan Zhang +10 more
wiley +1 more source
Advanced Engineering Materials, Volume 27, Issue 6, March 2025.The stability criteria affecting the formation of high‐entropy alloys, particularly focusing in supersaturated solid solutions produced by mechanical alloying, are analyzed. Criteria based on Hume–Rothery rules are distinguished from those derived from thermodynamic relations. The formers are generally applicable to mechanically alloyed samples.
Javier S. Blázquez +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study explores the lightweight potential of laser additive‐manufactured NiTi triply periodic minimal surface sheet lattices. It systematically investigates the effects of relative density and unit cell size on surface quality, deformation recovery, compression behavior, and energy absorption.
Haoming Mo +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Single realization stochastic FDTD for weak scattering waves in biological random media. [PDF]
IEEE Trans Antennas Propag, 2013 Tan T, Taflove A, Backman V.
europepmc +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source