Results 281 to 290 of about 158,703 (338)
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.This article demonstrates that encasing a hyperelastic balloon in an inextensible sleeve greatly increases its burst pressure. This simple mechanical behavior can be used to produce an asymmetric inflation‐deflation sequence for coupled balloons with different thicknesses so they could serve as a soft robot's rear and front anchors when driven from a ...
Ifat Gertler, Katherine J. Kuchenbecker
wiley +1 more source
3D Printing of Highly Electrically Conductive Zinc for Sustainable Electronics Applications
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.A 3D printable zinc ink system with active zinc particles in a shellac matrix is demonstrated. The results show high conductivity, stable performance of printed structures under varying humidity conditions, and promising application in disposable water‐activated batteries. This technology combining digital material assembly, reliable operation, and non‐
Xavier Aeby +5 more
wiley +1 more source
Printed Interconnects for Heterogeneous Systems Integration on Flexible Substrates
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.Key components (sensors, energy devices, communication devices, computing chips, and interconnects) of flexible hybrid electronic (FHE) system connected via conductive printed metal tracks. The figure in the insets shows out‐of‐plane printed interconnects providing opportunities for lithography‐free formation of VIAs, in‐plane access of UTCs pads, and ...
Abhishek Singh Dahiya +3 more
wiley +1 more source
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.The given research presents an innovative insole‐based device employing self‐powered triboelectric nanogenerators (TENG) for flatfoot detection. By integrating TENG tactile sensors within an insole, the device converts mechanical energy from foot movements to electrical signals analyzed via machine learning, achieving an 82% accuracy rate in flatfoot ...
Moldir Issabek +7 more
wiley +1 more source
An Injection‐Molded Modified Silicone Rubber for Cancer‐on‐Chip Applications
Advanced Materials Technologies, Volume 10, Issue 6, March 18, 2025.This study describes the characterization and application of an injection‐molded functionalized PDMS fluidic insert for the commercially available Micronit system. Modified PDMS can accommodate cell culture and is able to covalently bind proteins for long‐lasting coatings under flow‐conditions.
Ben J. Haspels +7 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.This study describes the fabrication of arrays of luminal tissue constructs for 3D luminal tissue modeling. An oil or media‐filled reservoir between constructs serves as a liquid barrier or bridge to regulate communication between lumens within the array for modeling multi‐tissue interactions in vitro. Abstract Cell‐lined luminal structures are crucial
Mouhita Humayun +9 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.The article overviews past and current efforts on caloric materials and systems, highlighting the contributions of Ames National Laboratory to the field. Solid‐state caloric heat pumping is an innovative method that can be implemented in a wide range of cooling and heating applications.
Agata Czernuszewicz +5 more
wiley +1 more source