Results 11 to 20 of about 22,818 (216)
International Journal of Electrochemical Science, 2013 In order to improve the specific capacity and rate capability of the electrodeposited Sn-Ni alloy, a post electrochemical dissolution treatment was introduced to prepare porous Sn-Ni alloy.
Chunhui Tan +7 more
doaj +1 more source
Green Energy & Environment, 2023 The extraction of lithium from salt lakes or seawater has attracted worldwide attention because of the explosive growth of global demand for lithium products.
Guolang Zhou +9 more
doaj +1 more source
EXPERIMENTAL INVESTIGATION ON ELECTROCHEMICAL MACHINING PARAMETERS
Diyala Journal of Engineering Sciences, 2017 The inherent characteristics of electrochemical machining (ECM) have large scale of advantages over the traditional machining technologies. ECM has been employed in this work to machining low carbon AISI1005 steel.
Dhia Ahmed Alazawi
doaj +1 more source
Corrosion of Indium in Chloride and Sulfate Electrolytes
Eurasian Chemico-Technological Journal, 2014 When the electrochemical purification of rough indium is used as sulfate, and chloride electrolytes. Significant differences in the values of the stationary potential indium electrode in the above solutions weren’t observed.
G. Rakhymbay +5 more
doaj +1 more source
Active electrochemical interfaces stabilized through self-organized potential oscillations
Electrochemistry Communications, 2020 Some electrochemical systems are known to have higher average efficiency when operated under an oscillatory regime. Given the compromise between activity and stability, the stability of electrochemical interfaces in a self-organized, oscillatory state ...
Jéssica A. Nogueira +3 more
doaj +1 more source
International Journal of Electrochemical Science, 2021 The effect of environmental conditions such as dissolved oxygen (DO) and temperature on electrochemical corrosion behavior of AISI 1018 low-carbon steel in concrete pore solution (CPS) were investigated.
Ming Li
doaj +1 more source
iScienceSummary: This study investigated the influence of electrolyte composition on the electrochemical dissolution behavior of 440C stainless steel. Dissolution characteristics were evaluated in six distinct electrolytes using electrochemical workstation ...
Xinyu Wen +5 more
doaj +1 more source
Electrochemical and wetting behavior of as-cast Sn-Zn-Sb lead free solders alloys [PDF]
Hemijska Industrija, 2013 Ternary alloys SnZn12Sb8, SnZn10Sb10, SnZn8Sb12, SnZn6Sb14, and SnZn2Sb18 were prepared by induction melting. Electrochemical behavior and wetting (contact angle) of prepared as-cast samples were investigated using open circuit potential measurement ...
Mladenović Srba A. +4 more
doaj +1 more source
Electrochemical Performance of SiC Composite Anode in Aluminum-Air Battery
Electrochemistry, 2020 The commercial pure aluminum (1A95) and its micro-alloyed with Mg and further particle composited with SiC were prepared using the vortex casting method, their electrochemical performances as the anodes in Aluminum-air batteries were investigated using ...
Mingcheng BING, Fan MO, Zhengfei HU
doaj +1 more source
A Study on the effect of C3H8O3 and C8O7 electrolytes for electro chemical machine performance of titanium alloys [PDF]
E3S Web of ConferencesElectrochemical Machining is a non-traditional machining process that uses electro- chemical reactions to remove materials from the workpiece. In this work , micro hole are produced on the titanium alloys with combination of C3H8O3 and C8O7 electrolytes ...
P Karthi +6 more
doaj +1 more source