Results 51 to 60 of about 87,880 (252)
Asymmetric Contact Engineering for Bottleneck‐Free Transport in 2D MoS2 Field‐Effect Transistor
Advanced Functional Materials, EarlyView.Performance of 2D semiconductor transistors is limited by carrier transport bottlenecks arising from specific device geometries. By identifying this structural limitation, a bottleneck‐free asymmetric transistor architecture (BATA) is introduced to improve carrier transport.
Jinhyeok Pyo +10 more
wiley +1 more source
High Entropy Wide‐Bandgap Borates with Broadband Luminescence and Large Nonlinear Optical properties
Advanced Functional Materials, EarlyView.High‐entropy rare‐earth borates exhibit excellent nonlinear optical and broadband luminescence properties arising from multi‐component doping, chemical disorder, increased configurational entropy, and increased lattice and electronic anharmonicity. This formulation enabled us to obtain a large, environmentally stable single crystal with 3X higher laser‐
Saugata Sarker +14 more
wiley +1 more source
High-temperature phase transitions in SrBi_2Ta_2O_9 film: a study by THz spectroscopy
, 2004 Time-domain THz transmission experiment was performed on a $\rm SrBi_2Ta_2O_9$ film deposited on sapphire substrate. Temperatures between 300 and 923 K were investigated and complex permittivity spectra of the film were determined.
C Kadlec +14 more
core +1 more source
Conductance‐Dependent Photoresponse in a Dynamic SrTiO3 Memristor for Biorealistic Computing
Advanced Functional Materials, EarlyView.A nanoscale SrTiO3 memristor is shown to exhibit dynamic synaptic behavior through the interaction of local electrical and global optical signals. Its photoresponse depends quantitatively on the conductance state, which evolves and decays over tunable timescales, enabling ultralow‐power, biorealistic learning mechanisms for advanced in‐memory and ...
Christoph Weilenmann +8 more
wiley +1 more source
Three-dimensional light-matter interface for collective spin squeezing in atomic ensembles
, 2013 We study the three-dimensional nature of the quantum interface between an ensemble of cold, trapped atomic spins and a paraxial laser beam, coupled through a dispersive interaction.
Baragiola, Ben Q. +5 more
core +1 more source
Advanced Functional Materials, EarlyView.Strong exciton‐photon coupling is achieved by integrating porphyrin ligand‐based MOF nanoparticles in optical cavities, as evidenced by pronounced polariton branch anticrossing. The porous nature of the resonator enables precise, reversible tuning via vapor pressure, unlocking unprecedented chemical‐environment controlled dynamic polaritonic platforms ...
Beatriz de Sola‐Báez +7 more
wiley +1 more source
Lasing in metamaterial nanostructures
, 2009 A self-consistent computational scheme is presented for one dimensional (1D) and two dimensional (2D) metamaterial systems with gain incorporated into the nanostructures. The gain is described by a generic four-level system. The loss compensation and the
Anan Fang +4 more
core +1 more source
Advanced Functional Materials, EarlyView.In this report, we demonstrate that a crystalline phase of 52nm thick NiFe2O4 can be grown by RF sputtering on top of γ‐Al2O3(8nm)/SrTiO3 at a significantly low temperature (150 °C) without compromising the mobility and carrier density of the 2D electron gas at the γ‐Al2O3(8nm)/SrTiO3 interface.
Amit Chanda +11 more
wiley +1 more source
Bio‐Inspired Molecular Events in Poly(Ionic Liquids)
Advanced Functional Materials, EarlyView.Originating from dipolar and polar inter‐ and intra‐chain interactions of the building blocks, the topologies and morphologies of poly(ionic liquids) (PIL) govern their nano‐ and micro‐processibility. Modulating the interactions of cation‐anion pairs with aliphatic dipolar components enables the tunability of properties, facilitated by “bottom‐up ...
Jiahui Liu, Marek W. Urban
wiley +1 more source
The suitability of N2 to replace SF6 in a triggered spark-gap switch for pulsed power applications [PDF]
, 2009 The high dielectric strength of sulphur hexafluoride (SF6) when compared with other gases, coupled with safety benefits such as non-flammability and non-toxicity, has seen the widespread use of SF6 for the insulation of switching components. However, SF6
Given, M.J. +6 more
core