Results 201 to 210 of about 726,846 (313)

Basic raw materials for VINYLS that wipe clean as new in seconds! [PDF]

, 1957

openalex   +1 more source

Influence of Temperature on Scratch and Wear Properties of Technical Thermoplastics: Implications for Material Selection

Advanced Engineering Materials, EarlyView.
The share of technical thermoplastics is expected to grow further in the e‐mobility segment. In this study, a detailed temperature‐based tribological characterization of technical thermoplastics is performed. The tribological properties are discussed in terms of the dynamic mechanical properties of polymers at different ambient temperatures. A proof of
Harsha Raghuram, Thomas Koch, Vasiliki-Maria Archodoulaki   +2 more
wiley   +1 more source

Effect of Chemical Polishing on the Formation of TiO₂ Nanotube Arrays Using Ti Mesh as a Raw Material. [PDF]

Nanomaterials (Basel)
Li W, Zhang S, Li F.
europepmc   +1 more source

X‐Ray Computed Tomography Quantifies Primary Phases and Reveals Crack Morphology in High‐Cycle Fatigue of Aluminum Alloy EN AW‐2618A

Advanced Engineering Materials, EarlyView.
Primary phases and a fatigue crack are studied in a forged blank of an aluminum alloy using synchrotron and laboratory X‐ray computed tomography. To image the crack, the fatigue test is interrupted, and a static tensile load is applied to open the crack.
Jakob Schröder, Ying Han, Tobias Fritsch, Bardia Hejazi, Alexander Ulbricht, Birgit Skrotzki, Giovanni Bruno   +6 more
wiley   +1 more source

Evaluation of mechanically extracted banana fibers from pseudostem layers: A sustainable textile raw material. [PDF]

Heliyon
Ruangnarong C, Khojitmate S, Srivorradatphisan S, Panyathikun N, Chonsakorn S.   +4 more
europepmc   +1 more source

Studies on the Polishing of Brown Rice used as the Raw material for Sake Brewing

, 1954
Kikuo NOSIRO, S. MATUDA, O. ISII, Satohiro Masuda   +3 more
openalex   +2 more sources

Mechanical Behavior and Microstructural Changes Associated with Tensile Deformation above the Martensite Start Temperature during Quenching and Subsequent Partitioning of a Low‐Alloy 37SiB6 Steel

Advanced Engineering Materials, EarlyView.
A new experimental setup, incorporating digital image correlation and infrared thermography in combination with inductive‐conductive heating for precise temperature control, is used to analyze the mechanical behavior and microstructural changes of sheet metal under complex thermomechanical test conditions that represent quench and partitioning ...
Christian Illgen, Benjamin Bohne, Sven Winter, Marcus Böhme, Martin F.-X. Wagner   +4 more
wiley   +1 more source

Impact of electric vehicle battery recycling on reducing raw material demand and battery life-cycle carbon emissions in China. [PDF]

Sci Rep
Jiang R, Wu C, Feng W, You K, Liu J, Zhou G, Liu L, Cheng HM.   +7 more
europepmc   +1 more source

Development of Aluminum Scandium Alloys for Hydrogen Storage Valves

Advanced Engineering Materials, EarlyView.
Different aluminum alloy series and various aluminum‐scandium alloys with differing Sc and Zr levels are evaluated for use in hydrogen storage valve production. The alloys undergo hardness testing, optical microscopy, and tensile strength analysis, with hardening behavior studied under varying conditions.
Francisco García‐Moreno, Tillmann Robert Neu, Markus Eberl, Paul Hans Kamm, Hans‐Wolfgang Seeliger   +4 more
wiley   +1 more source

Oak Leaves as a Raw Material for the Production of Alcoholic Fermented Beverages. [PDF]

Foods
Pencak T, Dordevic D, Ćavar Zeljković S, Tremlova B.   +3 more
europepmc   +1 more source