Results 101 to 110 of about 304,940 (242)
Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys
Advanced Engineering Materials, EarlyView.This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The subject of this work is the development of a corrosion‐protective coating on steel sheets for form hardening. Rapid heating in an extreme high vacuum (XHV)‐adequate atmosphere is a useful method to prevent oxidation during alloying of 22MnB5 and aluminum to obtain a metallurgical bonding.
Lorenz Albracht +5 more
wiley +1 more source
A Class of Mathematical Models Describing Processes in Spatially Heterogeneous Biofilm Communities
Biomath, 2014 We present a class of deterministic continuum models for spatially heterogeneous biofilm communities. The prototype is a single-species biofilm growth model, which is formulated as a highly non-linear system of reaction-diffusion equations for the ...
Stefanie Sonner
doaj +1 more source
A Feynman Path Integral-like Method for Deriving Reaction-Diffusion Equations. [PDF]
Polymers (Basel), 2022 Li C, Li J, Yang Y.
europepmc +1 more source
Surface Tension Measurement of Ti‐6Al‐4V by Falling Droplet Method in Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.In this article, the temperature‐dependent surface tension of free falling, oscillating Ti‐6Al‐4V droplets is investigated in both argon and monosilane doped, oxygen‐free atmosphere. Droplet temperature and oscillation are captured with one single high‐speed camera, and the surface tension is calculated with Rayleigh's formula.
Johannes May +9 more
wiley +1 more source
SoftwareXVariable coefficient equations are usually used as governing equations for modeling problems which are associated with Functionally Graded Materials (FGM). Version 1.1 - 2D-xtDCR-LTBEM is a Fortran code that can be used to find numerical solutions of two-
Mohammad Ivan Azis
doaj +1 more source
Modeling and Solution of Reaction-Diffusion Equations by Using the Quadrature and Singular Convolution Methods. [PDF]
Arab J Sci Eng, 2023 Ragb O +5 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.Cermets (60 vol.% AISI 316L stainless steel, 40 vol.% recycled MgO), intended for use in aluminum electrolysis, were pre‐oxidized in three furnaces with different heating technologies and subjected to a cryolite corrosion test. The different atmospheres influenced the formation of oxide layers, which in turn affected corrosion resistance and ...
Patricia Kaiser +4 more
wiley +1 more source
A Topology Optimization Framework for the Inverse Design of Nonlinear Mechanical Metamaterials
Advanced Engineering Materials, EarlyView.This work uses topology optimization to design unit cells for mechanical metamaterials with a prescribed nonlinear stress–strain response. The framework adds contact and postbuckling modeling to synthesize microstructures for three highly nonlinear responses, including pseudoductile behavior, monostable with snap‐through buckling, and bistable ...
Charlie Aveline +2 more
wiley +1 more source