Results 71 to 80 of about 9,780,048 (313)
A 3D‐Printed Model of Human Lactation
Breastfeeding supports infant and maternal health, yet in vitro models that mimic human lactation remain scarce. Here, light‐based 3D printing creates high‐resolution, alveoli‐inspired microwells that guide breast cells into polarized microtissues. The printed scaffolds embed slow‐release prolactin microcrystals to deliver hormonal cues, enabling human
Amelia Hasenauer, Marcy Zenobi‐Wong
wiley +1 more source
Design of a control system for a mobile torrefaction reactor
Thesis: S.B., Massachusetts Institute of Technology, Department of Mechanical Engineering, 2018.Cataloged from PDF version of thesis.Includes bibliographical references (pages 49-50).In MIT's Tata Center, work is being done to develop a mobile ...
Garcia, Alejandro, S.B. Massachusetts Institute of Technology
core
Ferroelectric Quantum Dots for Retinomorphic In‐Sensor Computing
This work has provided a protocol for fabricating retinomorphic phototransistors by integrating ferroelectric ligands with quantum dots. The resulting device combines ferroelectricity, optical responsiveness, and low‐power operation to enable adaptive signal amplification and high recognition accuracy under low‐light conditions, while supporting ...
Tingyu Long +26 more
wiley +1 more source
Massachusetts Institute of Technology Report MIT-5007
From summary: Report on the location, final design, and hazards analysis of the Massachusetts Institute of Technology Reactor Facility. It is hoped that the reactor plans described in this report may be approved from the safety standpoint, so that a ...
Benedict, Manson +3 more
core
Is embedding the reactor building below grade a cost-effective proposition?
Thesis: M. Eng., Massachusetts Institute of Technology, Department of Civil and Environmental Engineering, September, February, 2020Thesis: S.M., Massachusetts Institute of Technology, Department of Nuclear Science and Engineering, February ...
Velez, Enrique(Velez Lopez)
core
Metal‐free carbon catalysts enable the sustainable synthesis of hydrogen peroxide via two‐electron oxygen reduction; however, active site complexity continues to hinder reliable interpretation. This review critiques correlation‐based approaches and highlights the importance of orthogonal experimental designs, standardized catalyst passports ...
Dayu Zhu +3 more
wiley +1 more source
Analysis of the technological parameters of the advanced boiling water reactor. [PDF]
Perform advanced boiling water reactor technology, safety and economic parameters analysis, comparison with the older generation of reactor technology.
Klusavičius, Egidijus,
core +1 more source
Dynamic Behaviour of a Continuous Heat Exchanger/Reactor after Flow Failure [PDF]
The intensified technologies offer new prospects for the development of hazardous chemical syntheses in safer conditions: the idea is to reduce the reaction volume by increasing the thermal performances and preferring the continuous mode to the batch one.
Elgue, Sébastien +5 more
core
The engineering of colloidal nanocrystals with complex compositions has emerged as a highly active area of research within nanomaterials science. This review covers key aspects of colloidal solid‐solution nanocrystal formation using pulsed laser irradiation.
Marina T. Candela +4 more
wiley +1 more source
Fast and thermal neutron spectrum dosimetry measurements in the Advanced Test Reactor large-B and small-l positions following the sixth core internals change-out [PDF]
The Advanced Test Reactor (ATR) has a wide variety of irradiation positions that have had experiments that were developed by users from around the world. Most experiment irradiations rely on thoroughly benchmarked numerical models.
Reichenberger Michael +6 more
doaj +1 more source

