Results 91 to 100 of about 1,547 (217)
Electrochromic Adaptive Solar Heater and Sub‐Ambient Passive Daytime Radiative Cooler
An electrochromic Cu–Bi nanocluster device dynamically switches between solar heating and daytime sub‐ambient radiative cooling without mechanical motion. Defect‐activated graphene, minimized electrolyte loss, and pulse‐assisted reversible electrodeposition enable opposite solar and mid‐infrared modulation in one opaque platform, establishing a design ...
Chenxi Sui +11 more
wiley +1 more source
Rectangular Plate with Reinforcements
This investigation considers the problem of deflections and strength of the rectangular plate with reinforcements under general distribution of loading, and under the boundary conditions in which one pair of opposite edges normal to reinforcements are simply supported, the other pair of edges are elastically supported, by reinforcements.
openaire +2 more sources
Soft Skins With Reversible Thickness Morphing: Materials, Mechanisms, and Applications
Evolution of electronic skin (e‐skin) technologies toward adaptive, multifunctional soft skins. Phase I highlights early rigid and discrete sensory interfaces. Phase II shows the transition toward flexible, stretchable, and large‐area e‐skin. Phase III captures the emergence of computational e‐skin.
Oliver Ozioko +2 more
wiley +1 more source
This work introduces sustainable PLA/graphene oxide bioelectronic interfaces featuring electrodes with tunable conductivity and strong electrocatalytic performance. These platforms were used to implement a new method for tuning astrocyte Ca2+ signaling and for the efficient detection of key biomarkers.
Alessandra Scidà +15 more
wiley +1 more source
Vibration isolation performance analysis of laminated double-layer rectangular plate structure
Based on the spectral geometry method, the analytical model of laminated double-layer rectangular plate including elastic floating raft damping system is established.
Zhang Ying, Si Junling, Guo Zhanbin
doaj +1 more source
Defect‐Templated Phase Engineering in Atomically Thin Metals
Graphene defects are transformed from passive imperfections into programmable templates for phase‐selective growth of atomically thin silver. Plasma‐generated boundary defects favor Ag(1), whereas sp3‐rich zero‐layer graphene promotes Ag(2). This defect‐directed intercalation links local graphene chemistry to crystalline phase, electronic structure ...
Arpit Jain +25 more
wiley +1 more source
A thermoreversible gelatin‐based gel forms a soft, conformal bioelectronic interface on complex biological surfaces. The flowable precursor penetrates hair‐dense regions, solidifies in situ, and maintains low impedance through adaptive contact and hydration retention.
Ruinan Hao +9 more
wiley +1 more source
A microfluidic method is presented which enables parallelized fabrication of rod‐shaped microgels, based on step‐emulsification (SE) droplet generation and subsequent droplet distribution and confinement, combined in a single device. Microgel rods are fabricated in parallel at different flow rates based on two light‐mediated crosslinking chemistries ...
Matthias Mork +5 more
wiley +1 more source
Water harvesting, radiative cooling, and interfacial solar evaporation are fundamentally governed by coupled heat, mass, and light transport processes. These processes are mediated by pore architecture, including pore size, connectivity, and hierarchical organization.
Dejan J. Trajkovski +5 more
wiley +1 more source
Iterative Selection of DNA Nanostructures for Cellular Uptake
DNA nanostructures are promising cell targeting delivery vehicles for therapeutics, but the targeting behavior is not fully understood. In this study, libraries of DNA nanostructures that can be amplified and sequenced are combined with cellular uptake as a selection pressure to iteratively refine DNA structures taken up in cells to better understand ...
Anjali Rajwar +4 more
wiley +1 more source

