Results 251 to 260 of about 882,899 (290)
Some of the next articles are maybe not open access.
Vibration of Rectangular Plates
Journal of the Aeronautical Sciences, 1953Nagaraja, J. V., Rao, S. S.
openaire +2 more sources
Journal of the Structural Division, 1961
Structural model is described and analyzed for numerical solution; plate model consists of 2 groups of beams intersecting at right angles, one group being continuous over other; twisting moments in plate are carried by pairs of coil springs; loads are assumed to be concentrated at beam intersections; this procedure provides elastic surface, moments ...
openaire +1 more source
Structural model is described and analyzed for numerical solution; plate model consists of 2 groups of beams intersecting at right angles, one group being continuous over other; twisting moments in plate are carried by pairs of coil springs; loads are assumed to be concentrated at beam intersections; this procedure provides elastic surface, moments ...
openaire +1 more source
The Vibration of Rectangular Plates
Proceedings of the Institution of Mechanical Engineers, 1954In this paper are considered the free transverse vibrations of rectangular plates with all possible boundary conditions obtained by combining free, freely-supported, and fixed edges. The Rayleigh method, assuming waveforms similar to those of beams, is used to derive a simple approximate frequency expression for all modes of vibration.
openaire +1 more source
2009
We focus on special aspects of the theory of thin plates by discussing a state of constant bending curvature in Section 5.1 and a panel of constant torsion in Section 5.2. In Section 5.3 we show the effectiveness of a square simplysupported plate subject to a distributed load. In Section 5.4 we discuss the special case of a twist-less plate.
openaire +1 more source
We focus on special aspects of the theory of thin plates by discussing a state of constant bending curvature in Section 5.1 and a panel of constant torsion in Section 5.2. In Section 5.3 we show the effectiveness of a square simplysupported plate subject to a distributed load. In Section 5.4 we discuss the special case of a twist-less plate.
openaire +1 more source
Buckling of Rectangular Plates
2017The stability of rectangular plates with induced in-plane compressive stresses resulting from the mechanical or thermal loads is discussed in this chapter. The kinematical relations, constitutive law, the equilibrium equations, and the stability equations for a rectangular plate are derived and the classical boundary conditions are presented.
openaire +1 more source
Vibrations of Rectangular Plates
Journal of the Aeronautical Sciences, 1951openaire +2 more sources
Rectangular Plates with Stringers and Ribs
Journal of the Aeronautical Sciences, 1954Irving, J., Mullineux, N.
openaire +2 more sources
Thermal Bending of Rectangular Plate
Journal of the Aerospace Sciences, 1962Das, Y. C., Navaratna, D. R.
openaire +2 more sources