Results 31 to 40 of about 1,317 (206)
Recent Advances in Programmable Metasurfaces and Meta‐Devices
Programmable metasurfaces enable various novel functionalities by dynamically tuning electromagnetic wavefronts. This article provides a comprehensive review of recent advances in microwave and terahertz programmable metasurfaces, covering electrical, thermal, optical, and mechanical control mechanisms.
Linda Shao +4 more
wiley +1 more source
Technologies for Near-Field Focused Microwave Antennas
This paper provides a review spanning different technologies used to implement near-field focused antennas at the microwave frequency band up to a few tens of GHz: arrays of microstrip patches and printed dipoles, arrays of dielectric resonator antennas,
Paolo Nepa +3 more
doaj +1 more source
A CMOS‐compatible, all‐dielectric Silicon‐on‐Glass reflective metasurface enables low–loss terahertz wavefront control for future 6G wireless communication. Mie‐resonant silicon pillars provide full phase coverage near 500 GHz, achieving experimentally validated single‐, dual‐, and five‐beam steering with sub‐1.5° angular error and less than 3 dB ...
Rithwik Premanand +6 more
wiley +1 more source
Hardware-Efficient Hybrid Precoding for Millimeter Wave Systems With Multi-Feed Reflectarrays
Current hybrid precoding schemes for large-scale antenna array-aided millimeter wave (mmWave) wireless systems adopt either full-connected or sub-connected architectures based on phased array antennas (PAAs).
Zhengyi Zhou +3 more
doaj +1 more source
Social Network Optimization Based Procedure for Beam-Scanning Reflectarray Antenna Design
Evolutionary algorithms can be successfully exploited for carrying on an effective design of beam-scanning passive reflectarrays, even if the problem is highly non-linear and multimodal.
Alessandro Niccolai +4 more
doaj +1 more source
Direct nanoscratching with a 500 nm diamond lapping film creates groove‐guided liquid‐crystal alignment interfaces on PCB‐compatible Cu‐patterned RF substrates within minutes, eliminating polymer coating and high‐temperature baking. The coating‐free process enables optical/molecular alignment validation and voltage‐programmable 28 GHz reflection‐phase ...
Junseok Ma +5 more
wiley +1 more source
A Design Method to Increase the Bandwidth of Reflectarray Antennas
This work introduces a novel design methodology to redesign traditional reflectarray antennas (RAs) with bandwidths in the order of 15% and double their bandwidth without increasing their design complexity.
Christos Exadaktylos +3 more
doaj +1 more source
Bandwidth Enhancement of Single-Layer Microstrip Reflectarrays with Multi-Dipole Elements [PDF]
The gain bandwidth limit of a single-layer microstrip reflectarray is analyzed using multi-dipole elements. By observing the reflection phase characteristics of the multi-dipole elements with different numbers of dipoles, it is shown how the bandwidth ...
Ji Hwan Yoon, Young Joong Yoon
doaj +1 more source
Conceptual illustration of the retro‐reflective and transmissive metasurface (RRTM). The blue radar establishes communication with the UAV via the transmissive mode, whereas the purple surveillance radar acquires the status of friendly units through the retro‐reflective mode and the two modes operate simultaneously within the same decoupled aperture ...
Shulei Zhang +8 more
wiley +1 more source
Comparison of Synthesis Strategies for a Dual-Polarized Reflectarray
This paper presents and compares four optimization strategies for printed reflectarrays. They are applied to synthesize a dual-polarized reflectarray using two kinds of slot-loaded patches.
Loic Marnat +4 more
doaj +1 more source

