Results 171 to 180 of about 2,950,365 (215)
Analytical expression for the modulation bandwidth of a reflective semiconductor optical amplifier
An analytical formula for the bandwidth of a reflective semiconductor optical amplifier (RSOA) operated by directly modulating its injection current is derived. The formula allows gaining insight into the dependence of the RSOA modulation bandwidth on the main semiconductor parameters.
Antonio Mecozzi +2 more
exaly +5 more sources
Model simulations of a reflective semiconductor optical amplifier
A reflective semiconductor optical amplifier is modeled using a rate equation for the inversion and an expression for the outgoing field in terms of the incoming field and the instantaneous inversion, for both the cases of linear and nonlinear gain, while assuming modulation speeds well below the round-trip frequency.
van Iersel, M., Lenstra, D., Allaart, K.
openaire +3 more sources
Time Delay and Gain Reduction in Reflective Semiconductor Optical Amplifier
Amplification of picosecond optical pulses by reflective semiconductor optical amplifier (RSOA) is theoretically investigated using a high-precision time-domain model. It is demonstrated that, compared to conventional SOA in similar conditions, pulses amplified by RSOA suffer from additional gain reduction of a few dB due to RSOA’s rear-facet ...
Jacques W. D. Chi, Chi, Jacques W. D.
openaire +3 more sources
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Reflective Semiconductor Optical Amplifiers in passive optical networks
2009 14th OptoElectronics and Communications Conference, 2009Reflective Semiconductor Optical Amplifiers (RSOAs) offer a cost effective wavelength agnostic transmitter for applications within wavelength division multiplexed passive optical networks (WDM PONs) obviating the need for tuneable or fixed laser sources at customer premises.
Michie, C., Andonovic, I., Kelly, A.E.
openaire +4 more sources
Efficient Dynamic Wideband Model for Reflective Semiconductor Optical Amplifier
Optical Fiber Communication Conference/National Fiber Optic Engineers Conference 2013, 2013A computationally efficient, time-domain model for simulation of spatial-temporal distribution of photons and carriers in a bulk RSOA is presented. Saturation, noise, chirp and signal broadening are successfully predicted for NRZ and QPSK signals.
Zoran Vujicic +3 more
openaire +2 more sources
A new time-domain wideband numerical model for simulation of quantum dot-reflective semiconductor optical amplifier (QD-RSOA) steady-state and dynamic behavior, is described. The model is used to investigate 1 ps full-width at half-maximum input Gaussian
Khalil safari anzabi +2 more
exaly +1 more source
Multiwavelength conversion based on reflective semiconductor optical amplifiers
SPIE Proceedings, 2003In this contribution the routing capabilities of time/wavelength codes in Optical Code Division Multiple access are observed by means of the study of two devices for achieving the wavelength part code conversion. Multi-wavelength conversion will be achieved by using a Semiconductor Optical Amplifier and a Reflective Semiconductor Optical Amplifier. The
Antonio L. J. Teixeira +4 more
openaire +1 more source
A reflective semiconductor optical amplifier based all-optical header separator
Optoelectronics Letters, 2010An all-optical header extraction scheme based on the reflective semiconductor optical amplifier (RSOA) is presented, which can be used to process variable-length and bit-rate transparent packets. Through selecting the appropriate carrier-lifetime of the RSOA, the payload pulses obtain smaller gains than header pulses and are considered to be compressed.
Jun Zhao, Zong-biao Shao, Xiao-han Sun
openaire +1 more source
Novel optical regenerator using semi-reflective semiconductor optical amplifier
Integrated Photonics Research and Applications/Nanophotonics for Information Systems, 2005We propose and theoretically verify optical regenerator using single semi-reflective semiconductor optical amplifier. Using simplified gain model, we explaine operational principle of proposed regenerator. Simulaton result shows proposed scheme acts as 2R regenerator.
Tae-Young Kim, Sang-Kook Han
openaire +1 more source
Simple model for optical pulse propagation in a reflective semiconductor optical amplifier
Numerical Simulation of Optoelectronic Devices, 2010A simple time-domain model is presented that can predict optical pulse propagation in reflective semiconductor optical amplifiers (RSOAs). The RSOA saturation energy, effective lifetime and material gain coefficient parameters used in the model are determined using experimental measurements of the input and output pulse temporal profiles to the RSOA ...
M.J. Connelly, C. O'Riordan
openaire +1 more source

