Results 111 to 120 of about 11,192 (252)
Band Alignment and Composition of the Buried TiO2/GaInP Interface
Buried TiO2$\text{TiO}_2$/GaInP interfaces formed by mild plasma‐enhanced ALD are shown to be largely insensitive to the initial GaInP surface condition. Angle‐dependent photoelectron spectroscopy reveals similar interfacial chemistry and band alignment for phosphorus‐rich and naturally oxidized surfaces, demonstrating a robust pathway for reproducible
David Ostheimer +11 more
wiley +1 more source
Imide substitution with bulky 2,6‐isopropylphenyl groups induces perylene diimide to self‐assemble on Ag(111) into a monolayer with two coexisting adsorption heights. Molecules closer to the substrate gain metallic character due to charge transfer from the metal, while farther ones remain decoupled and semiconducting.
Giacomo Agnesod +12 more
wiley +1 more source
Hf–Zr–O‐based morphotropic phase boundary (MPB) thin films often suffer from limited endurance and poor uniformity due to intrinsic phase instability. This work proposes a nanolaminate architecture that spatially separates competing phases, stabilizes phase formation, and suppresses wake‐up‐induced degradation.
Hojung Jang, Hyunsang Hwang
wiley +1 more source
Milled polycrystalline NMC811 cathode (MPC NMC) with smaller secondary particle and higher surface area had 1) greater cathode tortuosity, 2) reduced surface Ni on the cycled MPC cathodes consistent with surface reconstruction, and 3) increased Ni deposition from cathode‐anode crosstalk, manifesting in lower functional capacity and higher impedance ...
Edelmy J. Marin Bernardez +22 more
wiley +1 more source
Skin‐Like Tri‐Modal Sensors Based on Soft Piezoelectric and Ionic Composites
Inspired by the multimodal perception of human skin, a soft, skin‐like tri‐modal sensor is presented. The device incorporates an ionically conductive, piezoelectric, elastic composite as its active layer, enabling independent detection of temperature, static strain, and dynamic strain within a single two‐terminal architecture.
Liren Wang +9 more
wiley +1 more source
The study considers the use of polymer/dielectric‐based multilayers piezoelectric Energy Harvesters (EH) to produce an output voltage and current, by exploiting the mechanical energy provided by human organs movements. In particular, the heart motion is considered from the kinematic viewpoint, and a multiphysics theoretical model is developed to assess
Hamdi Ezzin +5 more
wiley +1 more source
Fully Printed Electrocaloric Heat Pump
A system based on a flexible printed PEDOT:PSS/P(VDF‐TrFE‐CFE) electrocaloric membrane. The membrane periodically alternates between the cold and hot sides following its electrocaloric cycle and successfully generates a temperature difference. The entire fabrication process is industrially scalable, cost‐effective, and based on widely accessible ...
Adrian Agreda +7 more
wiley +1 more source
Ionized Keplerian Disks Demonstrating Interplay Between Strong Gravity and Magnetism. [PDF]
Stuchlík Z, Vrba J.
europepmc +1 more source
High‐Performance Piezoelectric Nanogenerators Based on Wurtzite BeO Nanowire Arrays
This study demonstrates high‐performance piezoelectric nanogenerators based on 1D BeO nanowire arrays. The BeO nanowires exhibit a high piezoelectric coefficient (∼15.8 pm V−1) and deliver an output voltage of ∼26.1 V and power density of ∼0.32 µW cm−2.
Yoonseo Jang +7 more
wiley +1 more source
Miniaturized Flexible Corrosion-Resistant Tag Antenna with Folding Arm Based on Graphene Film. [PDF]
Zeng M +6 more
europepmc +1 more source

