Results 261 to 270 of about 203,115 (309)
Some of the next articles are maybe not open access.

Concrete integral abutment bridges with reinforced concrete piles

Structural Concrete, 2014
AbstractThe use of reinforced concrete (RC) piles in integral abutment bridges (IABs) has not been widespread due to concerns over pile flexibility and the potential for concrete cracking. This is the reason why the use of steel piles is the preferred solution in the United States.
David Gama, João F. Almeida
openaire   +1 more source

Assessment of Reinforced Concrete Highway Bridges

Transportation Research Record: Journal of the Transportation Research Board, 2016
The primary contributor to the corrosion of bridges in Canada is heavy use of de-icing salts, which can lead to severe rebar corrosion and girder soffit spalling in reinforced concrete (RC) highway bridges. This paper discusses recent challenges faced by authorities in dealing with corrosion problems in Canadian highway bridges, and describes typical ...
Maria Anna Polak   +4 more
openaire   +1 more source

Aesthetics of reinforced concrete arch bridges [PDF]

open access: possible, 2015
Development of RC arches is presented in the paper and aesthetical parameters of more than hundred concrete arch bridges, built worldwide in past 140 years, are analysed. Aesthetics of representative bridges was questioned by surveys and discussed in the paper.
Radić, Jure   +2 more
openaire   +2 more sources

REINFORCEMENT CORROSION AND THE DURABILITY OF CONCRETE BRIDGES.

Proceedings of the Institution of Civil Engineers, 1984
Corrosion can arise in most parts of a bridge substructure or superstructure and usually results from the use of de-icing salts. Substructure corrosion is often associated with leaking joints, faulty drainage or salt spray from traffic. General corrosion is found on substructures and although this is a relatively slow process, producing only small ...
openaire   +1 more source

Corrosion Evaluation of Reinforced Concrete Bridges

Structures Congress 2005, 2005
Current inspection procedures used to assess bridge conditions subjected to corrosion of reinforcing steel involve the use of sounding technique (e.g. chain drag for bridge decks), half-cell potential test, chloride analysis and depth of cover measurement.
openaire   +1 more source

Durability Study of Reinforced Concrete Bridge

Applied Mechanics and Materials, 2012
Steel corrosion is the most important and direct factor of reinforced steel concrete bridge durability damage as well as one of the main forms of the concrete bridge durability destruction. This article gives a comprehensive discuss from the corrosion mechanism, influencing factors and consequences.
openaire   +1 more source

Discussion on Reinforced Concrete Bridges

Transactions of the American Society of Civil Engineers, 1907
Henry H. Quimby   +3 more
openaire   +1 more source

Reinforced Concrete Bridges

1999
John Kung, Jyouru Lyang, Don Lee
openaire   +1 more source

Long reinforced concrete bridges

Journal of the Franklin Institute, 1915
openaire   +2 more sources

Evaluation of FRP as a reinforcement for concrete bridges

1993
Fiber-Reinforced-Plastic Reinforcement for Concrete Structures : International Symposium: 28 March 1993, Vancouver, BC ...
Rahman, A. H.   +2 more
openaire   +1 more source

Home - About - Disclaimer - Privacy