Results 31 to 40 of about 1,586,861 (165)
Verification of strength resistance of sandy soil using small scale penetrometer tests
Przegląd Naukowy Inżynieria i Kształtowanie Środowiska, 2021 This study focuses on utilizing cone penetrometer models to determine strength (resistance) of sandy soil and also assessment how the relative density and the angle of friction effects on the measured cone penetration resistance in sandy soil.
Hiba D. Saleem +2 more
doaj +1 more source
Metals, 2020 The microstructure and properties of Copper-Graphite Composites (CGC) prepared by spark plasma sintering (SPS) based on two-step mixing and wet milling were investigated.
Jinping Liu +7 more
doaj +1 more source
Density currents and relative non‐pluripolar products [PDF]
Bulletin of the London Mathematical Society, 2021 12 ...
openaire +3 more sources
IEEE Access, 2020 This paper presents an attempt to evaluate the sensitivity of lattice parameters on the contact pressure instability of newly lattice brake disc.
Aminreza Karamoozian +4 more
doaj +1 more source
, 2019 This guide deals with relative density - an index that quantifies the degree of packing between the loosest and densest possible state of coarse-grained soils as determined by experiments.The guide is part of a series, which explain the execution of geotechnical classification experiments as carried out at the Geotechnical Engineering Laboratory at ...
Nielsen, Benjaminn Nordahl +1 more
openaire
Production and quality of yoghurt in dairy industry Zenica
Mljekarstvo, 2004 Nowadays, when consumers are more aware of influence of feed on the health, yoghurt gains higher importance. Therefore, its consumption raises everyday. It is perfect fermented milk and source of high valuable nutrients.
Sonja Bijeljac +2 more
doaj
Some aspects on geometric and matrix work-hardening characteristics of sintered cold forged copper alloy preforms [PDF]
Materials Research, 2013 Powder metallurgy (P/M) material subjected to plastic deformation results into densification, however the extended deformation would not only enhance the densification also supplements the strain hardening.
A Rajeshkannan +2 more
doaj +1 more source
Model Test of the Pullout Bearing Capacity of End-Bearing Torpedo Anchors
Journal of Marine Science and Engineering, 2022 Torpedo anchors (TAs) are regarded as one of the most efficient mooring solutions for taut mooring systems, and end-bearing TAs are a new type of TA that primarily relies on end-bearing plates at the tail to generate a pile-end resistance to improve ...
Gang Li, Jinli Zhang, Jia Liu
doaj +1 more source
3D Printed Gyroid Lattices with Graded Density for Advanced Ballistic Protection [PDF]
INCAS BulletinAdditive manufacturing enables the fabrication of complex cellular architectures with controllable mechanical properties, making triple periodic minimum surface area (TPMS) networks promising candidates for lightweight, energy-absorbing applications.
George Catalin CRISTEA +5 more
doaj +1 more source
MicromachinesThe low specific density and good strength-to-weight ratio make magnesium alloys a promising material for lightweight applications. The combination of the properties of magnesium alloys and Additive Manufacturing by the Laser Powder Bed Fusion (LPBF ...
Jan Jaroš +3 more
doaj +1 more source