Results 11 to 20 of about 748,380 (268)
IEEE Access, 2021 Inductors are cornerstone components in power electronics converters. Since winding loss is the dominant loss mechanism in these components, its accurate measurement is fundamental for the validation of the inductor’s operation and design.
Ernesto L. Barrios +3 more
doaj +1 more source
Impact of probability distribution on the uncertainty of resistance measurement [PDF]
ITM Web of Conferences, 2019 The paper presents studies on the influence of probability distributions on the expanded uncertainty of the resistance measurement. Choosing the correct probability distribution is very important to estimate of measurement uncertainty. The paper presents
Szczesny Stanisław +2 more
doaj +1 more source
Applied signal effect in the potentiometric method on the resistance measurements accuracy
International Journal of Metrology and Quality Engineering, 2018 In this paper, the effect of applying dc voltage and dc current sources in using the potentiometric method on the accuracy and the uncertainty of the resistance measurements is studied.
Ali Rasha S.M.
doaj +1 more source
Sensors, 2011 This article describes further development of a novel Non Destructive Evaluation (NDE) approach described in one of our previous papers. Here these sensors have been used for the first time as a Piecewise Continuous System (PCS), which means that they ...
Saad Nauman +2 more
doaj +1 more source
AIP Advances, 2022 A high-precision, high environmental adaptability thermometer based on proportional divider resistance is proposed for high-precision temperature measurement in a spaceborne environment subjected to large temperature variations.
Hongxing Yang +5 more
doaj +1 more source
A TECHNIQUE OF MEASURING OF RESISTANCE OF A GROUNDING DEVICE
Electrical engineering & Electromechanics, 2016 Introduction. Measurement of resistance of the grounding device (GD) by means of a three-electrode system. This requires not only the right choice of installation locations of measuring electrodes, but also the determination of the point of zero ...
I.V. Nizhevskyi, V.I. Nizhevskyi
doaj +1 more source
Method to Evaluate the Resistance–Capacitance Voltage Divider and Uncertainty Analysis
Energies, 2021 The resistance and capacitance parameters of a resistance–capacitance divider may change due to factors such as long-term operation, internal insulation flashover, and dielectric breakdown, which will affect the measurement characteristics of the ...
Yi Luo +6 more
doaj +1 more source
Sensors, 2020 In remote measurement systems, the lead wire resistance of the resistance sensor will produce a large measurement error. In order to ensure the accuracy of remote measurement, a novel lead-wire-resistance compensation technique is proposed, which is ...
Wei Li, Shusheng Xiong, Xiaojun Zhou
doaj +1 more source
The Measurement of Electrical Resistance [PDF]
Nature, 1894 Abstract In the present state of electrical science, the determination of the electric resistance of a conductor may be considered as the cardinal operation in electricity, in the same sense that the determination of weight is the cardinal operation in chemistry.
openaire +2 more sources
An approach to the low-resistance measurement [PDF]
Serbian Journal of Electrical Engineering, 2013 The paper presents the real instrument functional characteristics and describes the way of practical solutions of its performance improvement. It presents the design process of the instrument made for resistance measuring.
Radetić Radojle +3 more
doaj +1 more source