Design of High Performance Microstrip Dual-Band Bandpass Filter [PDF]
, 2015 This paper presents a new design of dual-band bandpass filters using coupled stepped-impedance resonators for wireless systems. This architecture uses multiple couple stubs to tune the passband frequencies and the filter characteristics are improved ...
Khajavi, N., Majidifar, S., Makki, S. V.
core +2 more sources
Improvement of YX42° Cut LiTaO3 SAW Filters with Optical Proximity Effect Correction Method
Micromachines, 2023 Due to the influence of the optical proximity effect (OPE), it is easy for a pattern of photoresistance to be inconsistent with a design pattern, thus damaging the performance of a SAW resonator. To solve this problem, this paper proposes an optimization
Ping Luo +9 more
doaj +1 more source
MKID development for SuperSpec: an on-chip, mm-wave, filter-bank spectrometer [PDF]
, 2012 SuperSpec is an ultra-compact spectrometer-on-a-chip for millimeter and submillimeter wavelength astronomy. Its very small size, wide spectral bandwidth, and highly multiplexed readout will enable construction of powerful multibeam spectrometers for high-
Barry, Peter S. +18 more
core +2 more sources
New studies on microstrip ring resonators for compact dual-mode dual- and triple-band bandpass filters [PDF]
, 1998 TS-14-3-13This paper deals with the proposal, design and implementation of a class of compact dual- and triple-band bandpass filters with two transmission poles in each passband using a single microstrip ring resonator. Two methods are first presented to
Luo, S, Zhu, L, Sun, S
core +1 more source
A new neural network technique for the design of multilayered microwave shielded bandpass filters [PDF]
, 2009 In this work, we propose a novel technique based on neural networks, for the design of microwave filters in shielded printed technology. The technique uses radial basis function neural networks to represent the non linear relations between the quality ...
Cañete Rebenaque, David +4 more
core +2 more sources
A single-mode tunable plasmonic sensor based on an 8-shaped resonator for cancer cell detection
Scientific Reports, 2023 In this paper, a novel 8-shaped resonator coupled to metal–insulator–metal waveguides is used for designing plasmonic filters and sensors. The resonator supports two resonance modes, which result in peaks in the transmission spectrum of the structure.
Mohammad Danaie +2 more
doaj +1 more source
Excitation Schemes of Plasmonic Angular Ring Resonator-Based Band-Pass Filters Using a MIM Waveguide
Photonics, 2019 This article describes the analysis and design of the excitation schemes of the plasmonic angular ring resonator-based band-pass filters using a metal-insulator-metal (MIM) waveguide.
Vishwanath Mittapalli, Habibulla Khan
doaj +1 more source
A fundamental limit on the performance of geometrically-tuned planar resonators [PDF]
, 2011 Geometric frequency tuning in planar electromagnetic resonators is common in many applications. It comes, however, at a penalty in the resonance quality, Q0. The literature traces the causes of such penalty often in terms of the shortcomings in the added
Beach, MA, Morris, KA, Naji, A, Warr, PA
core +2 more sources
MODELING OF BANDPASS FILTERS WITH ATTENUATION POLES USING PARALLEL COUPLING CHANNELS
Information and Telecommunication SciencesBackground. Microwave filters are critical components in modern communication systems, playing a fundamental role in signal processing by allowing specific frequency bands to pass while attenuating unwanted frequencies.
Костянтин Шевцов +1 more
doaj +1 more source
DESIGN OF COMPACT BANDPASS QUASI-ELLIPTIC MICROSTRIP FILTERS
Известия высших учебных заведений России: Радиоэлектроника, 2018 This paper considers an algorithm for development of the sixth order compact microstrip bandpass filters with quasi-elliptic characteristics. The proposed technique is applied for synthesis of two filters for the L- and X-band.
Roman E. Semernya +3 more
doaj +1 more source