Results 11 to 20 of about 3,215 (291)
IEEE Open Journal of Antennas and Propagation, 2023 We extend the autocorrelation-based approaches currently used in standards to full correlation-matrix-based approaches in order to identify correlation between both spatially adjacent and non-adjacent samples in reverberation-chamber measurements.
Kate A. Remley +9 more
doaj +1 more source
Hangkong gongcheng jinzhan, 2020 As the typical airborne equipment, it is of great significance to study the radiation effects of airborne radio station in high intensity radiation fields (HIRF).
YUAN Hongtao +3 more
doaj +1 more source
Reverberating chamber profile identification
IET Microwaves, Antennas & Propagation, 2012 This study proposes a model, based on the generalised K (GK) distribution, for identifying the reverberating chamber (RC) propagation channel profiles. Following this rationale, a parameter, given by a proper combination of GK parameters, is not only able to clearly distinguish between line-of-sight (LOS) and non-line-of-sight conditions, but it is ...
SORRENTINO, Antonio +3 more
openaire +2 more sources
Characterization of Reverberation Chamber - A Comprehensive Review
IEEE Access, 2020 This study presents a comprehensive review of the characterization techniques of a reverberation chamber (RC). After describing the limitations of the theoretical models for the determination of the lowest usable frequency (LUF) of a chamber, the ...
Jawad Yousaf +5 more
doaj +1 more source
FDTD modelling of reverberation chamber
Electronics Letters, 2005 The finite-difference time-domain (FDTD) method is applied to the simulation of a reverberation chamber. The real losses of the reverberation chamber are taken into account in a post-treatment process. The predicted results are compared with measured data and good agreement is reported.
Bonnet, Pierre +3 more
openaire +3 more sources
The Effect of Zigzag Boundaries on the Reverberation Chamber Performance
IEEE Access, 2021 The stirrer design is important in a reverberation chamber measurement system. Previous study shows that the rotating radius of the stirrer plays a key role for the stirrer performance. However, to identify the contribution from the structure, optimizing
Kai Chen, Qian Xu, Xueqi Shen, Chun Ren
doaj +1 more source
Buildings, 2021 Insufficient diffuseness is the major cause of the poor repeatability and reproducibility of building acoustical measurements in a reverberation chamber. Inaccurate results were reported for the prevailing methods in ISO and ASTM standards. Many previous
Shuying Zhang, Joonhee Lee
doaj +1 more source
A Fast Finite-Difference Time Domain Simulation Method for the Source-Stirring Reverberation Chamber
International Journal of Antennas and Propagation, 2017 Numerical analysis methods are often employed to improve the efficiency of the design and application of the source-stirring reverberation chamber. However, the state of equilibrium of the field inside the chamber is hard to reach.
Wenxing Li, Chongyi Yue, Atef Elsherbeni
doaj +1 more source
Frequency characterization of reverberation chambers [PDF]
Proceedings of Symposium on Electromagnetic Compatibility, 2002 A series of measurements to investigate the modal structure of a reverberation chamber were conducted at the Dahlgren Division of the Naval Surface Warfare Center, Dahlgren, Virginia. These measurements were Phase I of a project to determine the frequency dependent characteristics of the fields in a reverberation chamber.
M.O. Hatfield, M.B. Slocum
openaire +1 more source
Angle-Dependent Absorption of Sound on Porous Materials
Acoustics, 2020 Sound-absorbing materials are usually measured in a reverberation chamber (diffuse field condition) or in an impedance tube (normal sound incidence). In this paper, we show how angle-dependent absorption coefficients could be measured in a factory-type ...
Jose Cucharero +2 more
doaj +1 more source