Results 171 to 180 of about 230,918 (333)

Nitroxide‐Mediated Photo‐Polymerization: A Swiss Army Knife for Microfluidic Design

open access: yesAdvanced Materials Technologies, EarlyView.
This article illustrates the application of NMP2 to the rapid (less than 1 h) photostructuring and sealing of model structures intended for microfluidic applications. Remarkably, the careful design of resin composition allows completing these steps by simply spreading bare monomer (i.e., no added photoinitiator) on top of the bottom layer embedding ...
Carlo Gonzato   +5 more
wiley   +1 more source

Blinking-Based Identification of Single Dye Molecules in Ink. [PDF]

open access: yesAnal Chem
Khodabocus AJ   +8 more
europepmc   +1 more source

Dual‐Functional Ingestible Passive Capsules for High‐Throughput Intestinal Sampling with Sealed Containment and Targeted Drug Delivery

open access: yesAdvanced Robotics Research, EarlyView.
To address challenges in high‐throughput intestinal sampling with sealed containment and target drug delivery, we developed a dual‐functional ingestible passive capsule with a dual‐triggered control system based on pH‐response and mechanical actuation.
Libing Huang   +9 more
wiley   +1 more source

Magnetic Nanoparticles for Rhodamine B Depletion in Wastewater-Theoretical and Experimental Approach. [PDF]

open access: yesMolecules
Vochița G   +5 more
europepmc   +1 more source

Sialic Acid Sensing via Molecularly Imprinted Polymer on Laser‐Induced Graphene

open access: yesAdvanced Sensor Research, EarlyView.
Sialic acid is an important biomarker for oral and overall health. Salivary levels of sialic acid are linked with oral cancer and other diseases. We develop a point‐of‐care sensor for sialic acid, based on molecularly imprinted aminophenylboronic acid electropolymerized onto laser‐induced graphene.
Alexander V. Shokurov   +2 more
wiley   +1 more source

Data‐Driven Printability Modeling of Hydrogels for Precise Direct Ink Writing Based on Rheological Properties

open access: yesAdvanced Science, EarlyView.
A predictive model for 3D printability is developed by integrating rheological analysis, including the Large Amplitude Oscillatory Shear (LAOS) test, with machine learning. With prediction errors under 10%, the model shows that post‐extrusion recovery controls horizontal printability, while high‐strain‐rate nozzle flow dictates vertical printability ...
Eun Hui Jeong   +7 more
wiley   +1 more source

Fluorescence Mean-Lifetimes of a Series of Small and Bright Fluorescent Dyes. [PDF]

open access: yesLuminescence
Boni L   +7 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy