Results 51 to 60 of about 711,778 (240)
Theoretical and numerical simulation investigation of deep hole dispersed charge cut blasting
Drilling and blasting methods have been used as a common driving technique for shallow-hole driving and blasting in rock roadways. With the advent of digital electronic detonators and the need for increased production efficiency, the traditional blasting
Chengxiao Li +5 more
doaj +1 more source
The Blasting Vibration Characteristics of Layered Rock Mass under High-Pressure Gas Impact
Firstly, the experimental test of blasting vibration was carried out to study the propagation characteristics of the peak particle velocity (PPV) and dominant frequency (DF) of the blasting vibration of layered rock mass under high-pressure gas impact ...
Haixia Wei +4 more
doaj +1 more source
Dynamic response at the terminus of oblique intersecting joints subjected to stress waves
This study derives the propagation equation for stress waves impinging upon nonlinear oblique intersecting joints. It analyzes the dynamic response at the terminus of nonlinear oblique intersecting joints subjected to stress waves. Abstract To investigate the dynamic response at the terminus of oblique intersecting joints subjected to stress waves, a ...
Gang Hu +4 more
wiley +1 more source
Carbon emission assessment of tunnel infrastructures: From construction to operation
This study develops a lifecycle carbon accounting framework for tunnel infrastructures, covering design, construction, operation, maintenance, and dismantling. Applied to a subsea tunnel case, the framework reveals the carbon emission distribution among four typical tunnel types and highlights potential carbon offset methods for low‐carbon tunnel ...
Luyuan Long +4 more
wiley +1 more source
Based on the 90 datasets, ERT and four optimization algorithms were used to build four hybrid models to predict the UCS of the backfill body. The SMA‐ERT model was the most effective model, and it can reliably guide the design of the backfill ratio parameters. Abstract This study analyzed the feasibility of using titanium (Ti) tailings as a backfilling
Weijun Liu, Zida Liu, Zhixiang Liu
wiley +1 more source
Probabilistic natural gradient boosting and Gaussian process regression models accurately predict rate‐dependent rock strength across lithologies. Static strength and strain rate dominate, while geometric factors have minimal influence, enabling interpretable and uncertainty‐aware predictions for dynamic geomechanical applications. Abstract The dynamic
Hadi Fathipour‐Azar
wiley +1 more source
Burst morphology is a crucial indicator for evaluating the effectiveness of blasting, as it directly reflects the actual state of the blasting results.
Guoqiang Wang, Hui Chen, Jingkun Zhao
doaj +1 more source
Calculation of blast hole charge amount based on three-dimensional solid model of blasting rock mass
The development and use of intelligent drilling rigs make it available to obtain accurate lithology data of blast drilling. In order to make full use of drilling data to improve blasting efficiency, the following research was carried out.
YingXian Chen +5 more
doaj +1 more source
This research proposes an interpretable hybrid stacking ensemble framework, optimized by the Sparrow Search Algorithm, to enhance hard rock pillar stability prediction. By integrating six machine learning models—k‐nearest neighbors, support vector machines, random forests, Gradient Boosting Decision Tree, eXtreme Gradient Boosting, and Light Gradient ...
Ning Wang +3 more
wiley +1 more source
Developing a universal tunnel span classification from global tunnel databases
A universal tunnel span classification system is introduced that incorporates tunnel span, cross‐sectional area, typical tunnel types, and intended uses. Representative flatness ratio values are also provided for each span class. The classification is derived from a comprehensive database of 450 tunnel profiles from 47 countries.
Simon Heru Prassetyo +8 more
wiley +1 more source

