Predicting Strip Tearing in Cold Rolling Tandem Mill using Neural Network [PDF]
International Journal of Advanced Design and Manufacturing Technology, 2015 Strip tearing during cold rolling process has always been considered among the main concerns for steel companies. Several works have been done so far regarding the examination of the issue.
A. Haghani, A. R. Khoogar, F. Kumarci
doaj
A Study on Model of Cutting Roll Pass Profile Spread for Hot-Rolled U-Steel Sheet Pile
Teshugang, 2014 The test of grooved roll pass rolling process to simulate steel works mill with roll diameter 1 200 mm, length of roll body 2 200 mm, maximum rolling force 25 000 kN and mill power 1 000 kW by laboratory mill with roll diameter 130 mm, length of roll ...
周庆鹏, 王盼盼, 杨光, 杨雪
doaj
Research on Multi-System Coupling Vibration of a Hot Tandem Mill
MachinesVibration in hot tandem rolling mills has been a problem in the iron and steel industry mainly due to its unpredictability. In this work, vibration data of the second finishing mill (F2) stand of a hot tandem rolling mill are collected and analyzed, and ...
Yujie Liu +3 more
doaj +1 more source
Improvement of technological processes of bar rolling on the basis of temperature models [PDF]
, 2014 Mathematical models describing the thermal processes occurring in the deformation focus and process stream of the mill are created. Problems of optimization of technological regimes to achieve desired conditions for process of bar rolling and eliminate ...
Дубинский, Ф. С. +2 more
core
A Digital Twin Model for Automatic Width Control of Hot Rolling Mill [PDF]
, 2023 C. Song, Xiaohui Shen, Junchao Xia
openalex +1 more source
Review on Cold Rolling Mill Roll Deformation
MATTER: International Journal of Science and Technology, 2017 There are various reasons by which the damage in the cold rolling mill rolls occurs. The main objective is to highlight those reasons which are responsible for the breakage. The parameters considered during the manufacturing and during the regular use of rolls in cold rolling in the past researches and the effect of these parameters to increase the ...
Dr. Ravi Goyal +2 more
openaire +1 more source
Використання методу параметричної ідентифікації для контролю технічного стану робочих органів вертикального валкового млина AG-MPS 180 BK [PDF]
, 2010 Описана методика і вимірювальна система для зняття перехідної характеристики вертикального валкового млина (ВВМ). Проведено аналіз експериментальних даних – перехідних характеристик.
Заміховський, Л. М. +1 more
core
Influence of Concentration of Sodium Metasilicate and Descaling on the High Temperature Lubricating Effects Evaluated by Hot Rolling Mill [PDF]
, 2023 Hongliang Liu +6 more
openalex +1 more source
Teshugang, 2016 The numerical simulation of process of four stand tandem KOCKS mill continuous rolling Ф16 mm GCr15 bearing steel bar from Ф21.5 mm stock has been carried out by using DEFORM-3D three-dimensional heavy deformation thermal-mechanical coupled with elastic ...
李小龙 +4 more
doaj
Investigation into dynamics of a rolling body-bearing-support system in a cold rolling stand [PDF]
, 2012 University of Technology, Sydney. Faculty of Engineering and Information Technology.The objective of this thesis is to gain a good understanding of the chatter phenomenon incorporating the dynamic rolling model and mechanical system model of a rolling ...
Kim, YS
core