Fatigue &Fracture of Engineering Materials &Structures, Volume 49, Issue 7, Page 2929-2944, July 2026.ABSTRACT The fatigue and fracture behavior of self‐piercing rivet (SPR) joints between AA6016 aluminum sheets (1–2 mm) and DX54D steel (0.95 mm) was studied under 90°, 45°, and 0° multiaxial loading. Pure shear (90°) loading produced the highest fatigue strength, whereas multiaxial (45°) loading resulted in reduced performance, with pure tension (0 ...
Alan Woo +5 more
wiley +1 more source
Management of separated instruments using a loop technique: Case series with a rapid review. [PDF]
Dent Res J (Isfahan)Khademi A +3 more
europepmc +1 more source
Polymer Composites, Volume 47, Issue 12, Page 11187-11199, 20 June 2026.Effects of plasma surface treatment on adhesive bonding of PP/flax biocomposites. ABSTRACT The emphasis on environmental sustainability has accelerated the adoption of biocomposites as alternatives to synthetic composites. However, their low surface energy may limit adhesion in bonding applications.
Asil Ayaz +3 more
wiley +1 more source
Optimization of Plasma Welding Sequence and Performance Verification for a Fork Shaft: A Comparison of Same-Direction and Reverse-Direction Welding. [PDF]
Materials (Basel)Yang J +5 more
europepmc +1 more source
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, Volume 28, Issue 12, 17 June 2026.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
Effect of multilayer laser cladding on the microstructure and wear resistance of SiC/Ni60A coatings. [PDF]
Sci RepWang Z, Qi C, Wang K.
europepmc +1 more source
Removing Oxide Layers and Retaining Oxide‐Free Steel Surfaces by Polishing in Oxygen‐Free Atmosphere
Advanced Engineering Materials, Volume 28, Issue 12, 17 June 2026.In this study, the efficacy of wet mechanical polishing under an oxygen‐free atmosphere for deoxidation and the retention of an oxide‐free steel surface are elucidated using X‐ray photoelectron spectroscopy. The methodology proved successful; however, the results were highly dependent on the preparation of the solvents used to clean the samples after ...
Friedrich Bürger +2 more
wiley +1 more source
Optimization and Analysis of Refill Friction Stir Spot Welding (RFSSW) Parameters of Dissimilar Aluminum Alloy Joints by FE and ANN Methods. [PDF]
Materials (Basel)Bîrsan DC, Susac F, Teodor VG.
europepmc +1 more source
Effects of Latent Solvent Content on Tuning the Nanofiltration Performance of Nanofibrous Composite Membranes. [PDF]
Membranes (Basel)Cao XD, Shao YX, Wang Q, Lu TD, Zhong J.
europepmc +1 more source
Mechanical Properties of the AlCu4Mg1 Alloy Joint Manufactured by Underwater Friction Stir Welding. [PDF]
Materials (Basel)Szachogłuchowicz I +2 more
europepmc +1 more source