Three-dimensional coating and rimming flow : a ring of fluid on a rotating horizontal cylinder [PDF]
, 2013 The steady three-dimensional flow of a thin, slowly varying ring of Newtonian fluid on either the outside or the inside of a uniformly rotating large horizontal cylinder is investigated.
Wilson, Stephen +2 more
core +4 more sources
Investigating the effect of rotational degree of freedom on a circular cylinder at low reynolds number in cross flow [PDF]
, 2011 Numerical simulations of Vortex-Induced Vibrations (VIV) of a circular cylinder in cross flow with a rotational degree of freedom about its axis have been carried out by means of a finite-volume method.
Wissink, J +5 more
core +6 more sources
Steady rimming flows with surface tension [PDF]
, 2008 We examine steady flows of a thin film of viscous fluid on the inside of a cylinder with horizontal axis, rotating about this axis. If the amount of fluid in the cylinder is sufficiently small, all of it is entrained by rotation and the film is ...
Benilov, E.S. +2 more
core +4 more sources
Thermoviscous coating and rimming flow [PDF]
, 2012 A comprehensive description is obtained of steady thermoviscous (i.e. with temperature-dependent viscosity) coating and rimming flow on a uniformly rotating horizontal cylinder which is uniformly hotter or colder than the surrounding atmosphere.
Wilson, Stephen +2 more
core +5 more sources
Rotating Cylinder Turbulator Effect on the Heat Transfer of a Nanofluid Flow in a Wavy Divergent Channel [PDF]
Journal of Applied and Computational Mechanics, 2021 In this research study, the numerical Galerkin Finite Element Method (GFEM) is used for forced laminar convection heat transfer of Cu-water nanofluid in a divergent wavy channel including a rotating cylinder turbulator.
M. Hatami +4 more
doaj +1 more source
Heat transfer on a rotating cylinder in a restricted flow with narrow spaces by two walls
Nihon Kikai Gakkai ronbunshu, 2016 The local heat transfer on a rotating cylinder was measured by Mach-Zehnder interferometer. The rotating cylinder was set in a restricted flow with narrow spaces by two horizontal plates. The two plates were made by copper or polycarbonate.
Ryohachi SHIMADA +2 more
doaj +1 more source
DEVELOPMENT AND EVALUATION OF A POWER OPERATED CORN SHELLER. [PDF]
Journal of Soil Sciences and Agricultural Engineering, 2004 A power-operate corn sheller was constructed to investigate the effect of corn moisture content, concave clearance and cylinder rotating speed on the broken and whole corn kernels percentages, total losses percentage as well as shelling efficiency and
M. A. Mady
doaj +1 more source
Numerical simulation of the current, potential and concentration distributions along the cathode of a rotating cylinder Hull cell [PDF]
, 2006 Numerical simulations of the non-uniform current, potential and concentration distributions along the cathode of a rotating cylinder Hull (RCH) cell (RotaHull® cell) are performed using finite element methods.
E.P.L. Roberts +8 more
core +1 more source
Analysis of Mixed Convection inside an Enclosure in the Presence of a Rotating Grooved Cylinder [PDF]
Journal of Heat and Mass Transfer ResearchIn the present study, mixed convective heat transfer inside a square enclosure in the presence of a rotating cylinder with various numbers of grooves is presented.
Rahim Hassanzadeh +2 more
doaj +1 more source
Analytical Investigating of the Pattern of Yielding Initiation for a Rotating Hallow FGM Cylinder [PDF]
مجله مدل سازی در مهندسی, 2015 In this paper, the effect of radii ratio and material exponent parameters on the pattern of yielding initiation for a rotating hollow FGM cylinder is analytically investigated.
Mehdi Salmani Tehrani +1 more
doaj +1 more source