Results 1 to 10 of about 1,530 (119)
A DPS-PLL based rotor position estimation method for permanent magnet wind turbine
Aiming at the problem of slow response and low tracking accuracy in the synchronous reference frame phase-locked loop (SRF-PLL) estimation of the permanent magnet synchronous generator (PMSG) rotor position when the wind speed changes suddenly, a rotor ...
Linxin Yu +4 more
doaj +1 more source
This paper focuses on the performance analysis of a sensorless control for a Doubly Fed Induction Generator (DFIG) in grid-connected operation for turbine-based wind generation systems.
Gianluca Brando +2 more
doaj +1 more source
With the advantages of low cost, small size and high resolution, the magnetic encoder is suitable for permanent magnet synchronous motor. However, due to the installation accuracy and the motor vibration, the rotor position error from magnetic encoder ...
Zhipeng Yin, Jiaqun Xu
doaj +1 more source
In the working process of the gas bearings, the unbalanced force of the rotor will increase nonlinearly with the increase in the rotating speed, resulting in an increase in the rotor’s vibration amplitude.
Wenbo Wang +3 more
doaj +1 more source
Electrical angle delay resulting from inverter part and design errors causes rotor position errors. It significantly lowers motor control performance as the rotor position error rate increases owing to increased speed.
Seonhyeong Kim +3 more
doaj +1 more source
The rotor position value is the most important parameter in synchronous machines. In this paper, a MATLAB model of high-resolution rotor position determination at zero speed, without any position sensor, is presented for a non-saturated permanent magnet ...
Mazen M. A. Al Ibraheemi a +3 more
doaj +1 more source
A Hybrid Filtering Stage-Based Rotor Position Estimation Method of PMSM with Adaptive Parameter
The performance of sensorless control in a permanent magnet synchronous machine (PMSM) highly depends on the accuracy of rotor position estimation.
Linxin Yu, Dazhi Wang
doaj +1 more source
This article proposed a position signal-free field current estimation method for brushless synchronous starter/generator (BSSG). Generally, the estimation of the field current of BSSG depends on the position signals provided by a physical sensor or ...
Zan Zhang +4 more
doaj +1 more source
3D Rotor Position-Dependant MEC Modeling of Different Claw Pole Machine Topologies
The paper is aimed at a 3D magnetic equivalent circuit (MEC)-based modelling of claw pole synchronous machine topologies. Beyond the magnetic saturation and the armature magnetic reaction, the proposed modelling approach takes into consideration the ...
Roua Omri, Amina Ibala, Ahmed Masmoudi
doaj +1 more source
Rotor Position Alignment of FSTPI Based PMSM Drive Using Low Frequency Signal Injection
A PMSM drive with an incremental encoder or using sensorless control requires alignment to a predetermined rotor position (initial position) or initial rotor position detection at start-up.
Salih Baris Ozturk +3 more
doaj +1 more source

