Results 71 to 80 of about 6,407 (264)

Onset of Alveolization Processes in Sandstones Exposed to Salt Weathering

open access: yesBuildings
Sandstones of the Lourinhã Formation were studied. Alveolization is the major form of weathering on the façades of monuments near Peniche in the western region of Portugal. Salt weathering is an important cause of this degradation form.
Marco Ludovico-Marques, Carlos Chastre
doaj   +1 more source

Influences of sandstone superimposed structure and architecture on waterflooding mechanisms: A case study of Kumkol Oilfield in South Turgay Basin, Kazakhstan

open access: yesPetroleum Exploration and Development, 2014
Taking the Kumkol oilfield of high water cut in the South Turgay Basin, Kazakstan as an example, this article built the architecture models of meandering river sandstones, braided river sandstones and delta sandstones, and analyzed the influence of the ...
Lun ZHAO   +6 more
doaj   +1 more source

Sources of Sandstone [PDF]

open access: yesNature, 1872
YOUR geological readers will readily admit the importance of any hint that will assist them in determining the source from which a particular bed of sand or sandstone has been derived.
openaire   +2 more sources

Research progress and current status of dynamic wave propagation characteristics in rock mass: A review

open access: yesDeep Underground Science and Engineering, EarlyView.
This review elucidates the velocity–dispersion–attenuation coupling mechanisms of wave propagation in rock masses, compares six representative models, and reveals how pressure, temperature, mineral composition, and anisotropy jointly control dynamic responses in complex geological media.
Jiajun Shu   +8 more
wiley   +1 more source

Reservoir potential of the Haymana Formation submarine-fan sandstones in the Haymana Basin of Turkey

open access: yesJournal of Petroleum Exploration and Production Technology, 2019
Sedimentological and petrographic studies of the Haymana Formation sandstones identify a submarine fan in the Haymana Basin. This study is confined to outcrop samples from the submarine-fan sandstones (the L1, L2, and L3 sections) and focuses on ...
Aylin Gecer   +5 more
doaj   +1 more source

Mechanism and disaster control new technology of strong ground pressure manifestation in ultra‐large mining face

open access: yesDeep Underground Science and Engineering, EarlyView.
In response to the problem of strong mining pressure manifestation along the goaf roadway in a thick coal seam mining area, this study uses a new type of combined blasting roof cutting technology to effectively control the manifestation and deformation of mining pressure along the goaf roadway.
Xiaoding Xu   +6 more
wiley   +1 more source

Dynamic geo‐hydrogeological monitoring‐driven situational awareness for real‐time floor water inrush risk prediction in deep mining

open access: yesDeep Underground Science and Engineering, EarlyView.
The fused data extracted from the distributed monitoring system as the data basis, combined with dynamic geological data, are imported into a deep learning model. As the geological conditions of mining and excavation change, the risk of water inrush at the working face is retrieved in real time.
Yongjie Li   +4 more
wiley   +1 more source

Performance assessment of a potential underground thermal storage facility: Case study of the closed mine Prosper‐Haniel in the Ruhr coal mining area in Germany

open access: yesDeep Underground Science and Engineering, EarlyView.
This study demonstrates the feasibility of an underground closed‐loop thermal storage facility at a post‐mining site, intended for seasonal heat energy storage. Its principal design shows water flow directions in winter and summer (1, 2), heat pumps (3), an upper water reservoir (4), and connecting pipes (5).
Dmytro Rudakov, Oleksandr Inkin
wiley   +1 more source

Probabilistic prediction of rate‐dependent rock strength using natural gradient boosting and Gaussian process regression

open access: yesDeep Underground Science and Engineering, EarlyView.
Probabilistic natural gradient boosting and Gaussian process regression models accurately predict rate‐dependent rock strength across lithologies. Static strength and strain rate dominate, while geometric factors have minimal influence, enabling interpretable and uncertainty‐aware predictions for dynamic geomechanical applications. Abstract The dynamic
Hadi Fathipour‐Azar
wiley   +1 more source

Rock mechanical properties under reconstructed deep in situ thermo–hydro–mechanical conditions: Implications for CO₂‐related injection scenarios

open access: yesDeep Underground Science and Engineering, EarlyView.
The graphical abstract illustrates a reconstructed in situ thermo‐hydro‐mechanical (THM) framework in which porosity serves as the central variable linking stress, pore pressure, and temperature to evolving mechanical properties of rocks. Under burial conditions, in situ stress, pore pressure, and temperature jointly govern volumetric strain and ...
Mingyuan Lu   +5 more
wiley   +1 more source

Home - About - Disclaimer - Privacy