Results 81 to 90 of about 1,143,277 (293)
Room temperature ferromagnetism in chemically synthesized ZnO rods [PDF]
We report structural and magnetic properties of pure ZnO rods using X-ray diffraction (XRD), magnetization hysteresis (M-H) loop and near edge x-ray fine structure spectroscopy (NEXAFS) study at O K edge.
B.H. Koo +22 more
core +1 more source
Powder metal processing provides scalable advantages in nanoporous (np) metal development. Mechanical alloying is used to produce unique precursors for hybrid nanopore formation by oxide reduction and dealloying. As demonstrated in np Ag, this approach improves process efficiency while promoting smaller ligaments and larger pores, both of which are ...
Mark A. Atwater, Oliver A. Fowler
wiley +1 more source
Effects of dental probing on occlusal surfaces - A scanning electron microscopy evaluation [PDF]
The aim of this clinical-morphological study was to investigate the effects of dental probing on occlusal surfaces by scanning electron microscopy (SEM).
Bodecker CJ +22 more
core +1 more source
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Recent improvements in correlative light and electron microscopy (CLEM) technology have led to dramatic improvements in the ability to observe tissues and cells.
Shinsuke Shibata +19 more
doaj +1 more source
Noise2Atom: unsupervised denoising for scanning transmission electron microscopy images
We propose an effective deep learning model to denoise scanning transmission electron microscopy (STEM) image series, named Noise2Atom, to map images from a source domain S $\mathcal {S}$ to a target domain C $\mathcal {C}$ , where S $\mathcal {S}$ is ...
Feng Wang +3 more
doaj +1 more source
Correct interpretation of actinomycete imagery using scanning electron microscopy [PDF]
Antibiotic discovery was one of the most significant advances in therapeutic medicine following the advances in fermentation technology owing to Howard Florey and his associates.
D. Ipek Kurtböke
doaj
A Workflow to Accelerate Microstructure‐Sensitive Fatigue Life Predictions
This study introduces a workflow to accelerate predictions of microstructure‐sensitive fatigue life. Results from frameworks with varying levels of simplification are benchmarked against published reference results. The analysis reveals a trade‐off between accuracy and model complexity, offering researchers a practical guide for selecting the optimal ...
Luca Loiodice +2 more
wiley +1 more source
Our laboratory undertook extensive light, transmission (TEM) and scanning elctron microscope (SEM) studies of rat lenses during the development and reversal phase of galactose-induced cataracts. These studies were undertaken in order to gain insight into the morphological manifestation of known biochemical changes that accompany development and ...
Nalin J. Unakar +3 more
openaire +1 more source

