Results 211 to 220 of about 199,214 (274)

Optofluidic Raman Analysis and Capacity Recovery in Li‐ion Cells

open access: yesAdvanced Materials Technologies, EarlyView.
Operando Raman spectroscopy is used to monitor the degradation of commercial Li‐ion cells. Using a microfluidic access port, small amounts of electrolyte are sampled into a hollow‐core optical fibre, where fibre‐enhanced Raman analysis reveals Li+ solvation changes and solvent evolution.
Ermanno Miele   +9 more
wiley   +1 more source

Enhanced Self‐Phase Modulation in Silicon Nitride Waveguides Integrated With 2D MoS2 Films

open access: yesAdvanced Materials Technologies, EarlyView.
ABSTRACT On‐chip integration of 2D materials provides a promising route toward next‐generation integrated optical devices with performance beyond existing limits. Here, significantly enhanced spectral broadening induced by self‐phase modulation (SPM) is experimentally demonstrated in silicon nitride (Si3N4) waveguides integrated with 2D monolayer ...
Shahaz S. Hameed   +15 more
wiley   +1 more source

Extreme‐Temperature Resistant, Flexible, and Sensitive Strain Sensor for Aerospace Parachute Deployment

open access: yesAdvanced Materials Technologies, EarlyView.
In this study, we report a resistive‐type strain sensor fabricated using single‐walled CNTs, are used layer using the pray technique to deposit as conductive, and UV‐resin was spin‐coated as a protection layer. The sensor functioned in harsh temperature variation conditions from −50°C to 125°C without deterioration.
Jagan Singh Meena   +4 more
wiley   +1 more source

Ultrafast (1‐5 sec) Lamination of Perovskite Solar Cells With Self‐Encapsulation Using Rapid Joule Heating

open access: yesAdvanced Materials Technologies, EarlyView.
Halide perovskite solar cells are fabricated with self‐encapsulation by lamination between two glass substrates using rapid Joule heating, yielding a 99% reduction in lamination time compared to previous studies. An 18% efficient cell is laminated in 5 s, demonstrating the potential for scalable manufacturing. ABSTRACT Perovskite solar cells (PSCs) are
Oluka Okia   +9 more
wiley   +1 more source

Bridging Mid- and Near-Infrared by Combining Optomechanics and Self-Mixing. [PDF]

open access: yesACS Photonics
Gabbrielli T   +10 more
europepmc   +1 more source

3D Printing of Stretchable, Compressible and Conductive Porous Polyurethane for Soft Robotics

open access: yesAdvanced Materials Technologies, EarlyView.
A 3D‐printable porous dopamine‐polyurethane acrylate elastomer results in conductive, stretchable, and compressible structures that can be metallized in situ through catechol‐mediated silver reduction. The resulting material function as both compliant soft robot with a and strain sensors without complex assemblies, enabling fully 3D‐printed soft ...
Ouriel Bliah   +3 more
wiley   +1 more source

Tunable Extraordinary Optical Transmission in the Long‐Wavelength Infrared Range Using Electrostatic MEMS Actuation

open access: yesAdvanced Materials Technologies, EarlyView.
A MEMS‐integrated metamaterial filter enables continuous, low‐voltage spectral tuning in the long‐wavelength infrared (LWIR). The device employs extraordinary optical transmission in a dual suspended metasurface stack, where electrostatic actuation precisely controls the intermembrane air gap.
Oleg Bannik   +6 more
wiley   +1 more source

Vision‐Augmented Wearable Interfaces: Bioinspired Approaches for Realistic AI‐Human‐Machine Interaction

open access: yesAdvanced Materials Technologies, EarlyView.
This review presents recent progress in vision‐augmented wearable interfaces that combine artificial vision, soft wearable sensors, and exoskeletal robots. Inspired by biological visual systems, these technologies enable multimodal perception and intelligent human–machine interaction.
Jihun Lee   +4 more
wiley   +1 more source

Home - About - Disclaimer - Privacy