Results 111 to 120 of about 4,633 (262)

Electrical Properties and Interfacial Strain in Thermally Oxidized 4H‐SiC MOS Structures Under Different Post‐Oxidation Annealing

open access: yesAdvanced Electronic Materials, EarlyView.
This work investigates the electrical properties and interfacial strain in thermally oxidized 4H‐SiC MOS structures under different post‐oxidation annealing. Nitrogen annealing simultaneously reduces interface state density and increases interfacial tensile strain, thus being accompanied by the formation of an interfacial dipole.
Fabrizio Roccaforte   +9 more
wiley   +1 more source

Decoupled Dielectric Optimization and YbOx Contact Engineering in All‐Spray‐Processed Oxide Thin‐Film Transistors

open access: yesAdvanced Electronic Materials, EarlyView.
Fully spray‐processed oxide thin‐film transistors are advanced by decoupling dielectric quality from contact energetics. Thermochemically densified MgO suppresses defect‐mediated leakage and improves electrostatic control, while an ultrathin YbOx interlayer induces a 1.67 eV work‐function shift that boosts mobility from ∼40 to ∼94 cm2 V−1 s−1.
Ahmed Mohamed   +5 more
wiley   +1 more source

Harnessing the VO2 Phase Transition for Automatic Gain Control in Transimpedance Amplifiers

open access: yesAdvanced Electronic Materials, EarlyView.
A nanoscale VO2‐based volatile switch integrated into a transimpedance‐amplifier feedback loop dynamically lowers gain when input current rises, preventing saturation and extending dynamic range. Rapid self‐recovery restores high sensitivity without external reset circuitry.
Amir Gildor   +3 more
wiley   +1 more source

Enhanced Thermoelectric Performance of GeTe‐Sb2Te3 Pseudo‐Binary Phase Change Material Through Stoichiometry Optimization

open access: yesAdvanced Electronic Materials, EarlyView.
A GeTe‐Sb2Te3 composition spread is fabricated using RF magnetron co‐sputtering. Increasing Sb content stabilized the high‐performance cubic GeTe phase. The composition 5Sb3₇Te5₈ exhibited the highest thermoelectric performance, achieving a power factor of ∼1 mW m−1 K−2 and a maximum zT of 0.81 at 300°C.
Nur Qalishah Adanan   +9 more
wiley   +1 more source

Dynamic Landau–Khalatnikov Modeling of Ferroelectric Hafnium–Zirconium Oxides Across Volatile and Non‐Volatile Switching

open access: yesAdvanced Electronic Materials, EarlyView.
Compositionally engineered hafnium–zirconium oxide capacitors are described by an extended Landau–Khalatnikov framework incorporating inertial and nonlinear damping terms. The unified model captures ferroelectric and volatile regimes within a single material platform, linking free‐energy landscapes to circuit‐level behavior.
Davide Rossetti   +15 more
wiley   +1 more source

Smart Exploration of Perovskite Photovoltaics: From AI Driven Discovery to Autonomous Laboratories

open access: yesAdvanced Energy Materials, EarlyView.
In this review, we summarize the fundamentals of AI in automated materials science, and review AI applications in perovskite solar cells. Then, we sum up recent progress in AI‐guided manufacturing optimization, and highlight AI‐driven high‐throughput and autonomous laboratories.
Wenning Chen   +4 more
wiley   +1 more source

Stream channel storage: Closing the watershed total phosphorus budget. [PDF]

open access: yesJ Environ Qual
Beck WJ   +11 more
europepmc   +1 more source

Nanocrystalline LCO/LLZO Composite Cathode Films for Solid State Batteries

open access: yesAdvanced Energy Materials, EarlyView.
A single precursor solution is solution‐deposited and calcined at only 750°C to yield a dense, nanograined LiCoO2/LLZO composite cathode, in which both phases crystallize independently with minimal interdiffusion. Assembled into all‐solid‐state Li‐metal batteries, the composite delivers 111.7 mAh g−1 initial discharge capacity and retains 93% after 100
Lucie Quincke   +8 more
wiley   +1 more source

Home - About - Disclaimer - Privacy