Results 181 to 190 of about 381,423 (286)

Does Long‐Term Lower Extremity Strength Training in Adults With Knee Osteoarthritis and Varus Alignment Reduce Knee Joint Loading During Gait?

open access: yesArthritis Care &Research, EarlyView.
Objective We examined whether 18 months of strength training in individuals with knee varus alignment and medial tibiofemoral osteoarthritis (OA) reduced knee joint loads during walking compared to an attention control group. Methods This study was a secondary analysis of a randomized clinical trial that compared the effects of strength training to a ...
Stephen P. Messier   +12 more
wiley   +1 more source

Experimental Evaluation of 100Cr6 Steel Microindented Surfaces Under Lubricated Nonconformal Point Contacts

open access: yesAdvanced Engineering Materials, EarlyView.
The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi   +3 more
wiley   +1 more source

Comparison of ocular biometry and refractive outcome between a new and classic optical biometer. [PDF]

open access: yesJ Cataract Refract Surg
Lin H   +8 more
europepmc   +1 more source

Is Young's Modulus a Critical Coating Property Determining Fouling‐Release Performance of Marine Coatings?

open access: yesAdvanced Engineering Materials, EarlyView.
The release of foulers from protective marine coatings is determined by several interrelated material properties, including the strength of Young's modulus, the flexibility of chain segments, the surface free energy, and the magnitude of hydrodynamic stress.
Johann C. Schaal   +2 more
wiley   +1 more source

Process‐Informed Analysis of As‐Built Metal Additive Surface Features

open access: yesAdvanced Engineering Materials, EarlyView.
This article introduces a novel method for feature‐based surface texture characterisation directly incorporating manufacturing variables into the feature extraction workflow. This marks a major step towards identifying process‐specific surface properties and their influence on part function and hence a holistic understanding of process–structure ...
Theresa Buchenau   +5 more
wiley   +1 more source

The Impact of High‐Productivity Processing on the Fatigue Failure of an Additive Manufactured Superalloy HAYNES 282

open access: yesAdvanced Engineering Materials, EarlyView.
The low cycle fatigue life of additive manufactured HAYNES® 282® superalloy was investigated for conventional and high‐productivity processing: samples of the former lasted 1400–1700 cycles, while samples of the latter failed at ~ 1200 cycles, at 760 °C and 1% strain.
Abdul Shaafi Shaikh   +3 more
wiley   +1 more source

Home - About - Disclaimer - Privacy