Results 131 to 140 of about 5,824,919 (291)

Post-stack inversion of seismic reflection data from the belvoir coalfield [PDF]

, 1995
Post-Stack inversion of reflection data in seismic exploration can be used to obtain detailed information about lithology variations in the zone of interest. Generalized Linear Inversion (GLI) has previously been applied as a useful tool to achieve this.
Gang, Tian
core  

Three‐Dimensional Analytical Model of a Podium Structure With Rocking Columns of Square Cross Section

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Allowing structural systems to uplift and rock during seismic excitation has emerged as an effective and inherently self‑centering form of seismic isolation. This paper develops a computationally efficient 3D analytical model suitable for the understanding of the behavior of rocking bridges.
Dimitra Adamopoulou, Michalis F. Vassiliou   +1 more
wiley   +1 more source

Spatiotemporal characteristics of the energy field and disaster cause of the 2023 Gansu Jishishan M6.2 earthquake

Geomatics, Natural Hazards & Risk
Anomalies in the seismic energy field and the temporal and spatial evolution characteristics of seismic energy can be used to improve earthquake predictions and rapid seismic hazard assessments.
Guofu Luo, Yingcai Xu, Hengzhi Luo, Wenjun Li, Bingzheng Hou   +4 more
doaj   +1 more source

Displacement Estimation of Structures With Flag‐Shaped Hysteresis Loops

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Time‐history analyses were conducted on single‐degree‐of‐freedom (SDOF) systems with flag‐shaped hysteresis loops using a far‐field ground motion suite to estimate peak displacements, Δp, and equivalent deformation cycles, Nc, associated with cumulative displacement demands.
Yudi Zhang, Gregory A. MacRae, Geoffrey W. Rodgers, Shahab Ramhormozian, Charles Clifton, Masoumeh Farshbaf   +5 more
wiley   +1 more source

Enhancing the Seismic Resilience of Masonry‐Infilled RC Structures Using Rubber Joints: Full‐Scale 3D Shaking Table Tests

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Masonry infills in reinforced concrete (RC) frames are highly vulnerable to seismic damage, often sustaining severe cracking even under moderate ground motion, which in turn leads to considerable economic losses and safety risks. To address this issue, this study experimentally evaluates the effectiveness of two innovative rubber‐based joints ...
Enrico Tubaldi, Marko Marinković, Simone Galano, Alessandro Lotti, Fabio Freddi, Daniele Losanno, Hamid Ahmadi, Matjia Gams, Nemanja Krtinić, Matija Bošković, Christoph Butenweg, Prateek Kumar Dhir, F. Manojlovski, A. Bogdanovic, Zoran Rakicevic, Vlatko Sheshov, J. Bojadzieva   +16 more
wiley   +1 more source

Direction‐Aware Period Prediction for Seismic Risk Assessment and Application to an Urban Tall Building Portfolio in China

Earthquake Engineering &Structural Dynamics, EarlyView.
ABSTRACT Reliable estimation of the principal periods is essential for regional seismic risk assessment (RSRA) of urban building portfolios. For tall buildings, however, existing period‐prediction formulas are constrained by the lack of representative data, while building translational azimuths are neglected despite their importance for regional ...
Zi‐Nan Wu, Ahmed Y. Elghazouli, Mengjie Xiang   +2 more
wiley   +1 more source

Optimization of Blasting‑Induced Roof Cutting Parameters in Key Stratum and Its Application in Gob‑Side Entry Retention Technology

Energy Science &Engineering, EarlyView.
This study addresses hard roof coal seam conditions by optimizing key stratum blasting‐cutting parameters through theoretical analysis, numerical simulation, and field tests. It proposes calculation methods for blast hole spacing and delay timing based on stress wave theory, controlling roadway deformation within 35 mm, thereby enhancing resource ...
Qiong Liu, Duanxiang Fu, Hongbin Li
wiley   +1 more source

Characteristics Analysis and Stage Division of Class Ⅰ Gas Hydrate Deposit Developed by Vertical Well and Depressurization Based on Numerical Analysis

Energy Science &Engineering, EarlyView.
The production process can be divided into two stages according to the relationship between the gas production rate and the decomposition gas rate. The ratio of cumulative decomposition gas to cumulative gas production can be used to evaluate the contribution of the gas hydrate layer.
Nu Lu, Bo Zhang, Jian Hou, Yajie Bai, Yongge Liu   +4 more
wiley   +1 more source

Study on Fluid Pressure in Tubing, Dynamic Stress in Reservoir, and Fracture Propagation Morphology During Variable‐Rate Hydraulic Fracturing

Energy Science &Engineering, EarlyView.
Variable‐rate hydraulic fracturing can induce unsteady flow in the tubing, thereby generating fluctuating fluid pressure near the bottom‐hole reservoir. Dynamic stress is generated in the reservoir under the action of fluctuating fluid pressure and propagates as stress waves.
Zhu Ge, Wang Chaojing, Li Weicheng
wiley   +1 more source

Deterministic Cost Estimation Approaches for Carbon Capture, Utilization, and Storage: A Review

Greenhouse Gases: Science and Technology, EarlyView.
ABSTRACT Carbon capture, utilization, and storage (CCUS) is regarded as a connection between traditional, high‐emission sectors and future green energy. This study encompasses literature from 2003 to early 2026 to review methodologies and formulae used for cost estimating in the various segments of carbon capture, transport, utilization, and storage ...
Majid Mohajeri, Saman Azadbakht
wiley   +1 more source