Results 31 to 40 of about 46,186 (258)

Planar Solid‐State Nanopores Toward Scalable Nanofluidic Integration Based on CMOS Technology

Advanced Engineering Materials, EarlyView.
We present a scalable silicon‐based fabrication strategy for planar solid‐state nanopores to enable their integration with complex nanofluidic systems. Prototype devices demonstrate normal voltage‐current characteristics, good noise performance, and appreciable streaming currents. Our CMOS‐compatible fabrication process offers precise geometric control
Ngan Hoang Pham, Chenyu Wen, Mohammad Hadi Khaksaran, Won‐Yong Lee, Javier Cruz, Klas Hjort, Dongping Wu, Shi‐Li Zhang   +7 more
wiley   +1 more source

About loading of autotransformers in main electrical grids and conclusions for designing

E3S Web of Conferences, 2017
The justification issues and the capacity selection of autotransformers in the main electrical grids, which require the accounting of the operation regimes of power units for the future of 10 or more years are considered.
Vasilenko Nikita, Plotnikov Vladislav, Shuntov Andrey   +2 more
doaj   +1 more source

Electrochemical Evaluation of Compressed Selective Laser Melted AlSi7Mg and AlSi10Mg Alloys in Chloride Environment

Advanced Engineering Materials, EarlyView.
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin, Samson Dare Oguntuyi, Peter Apata Olubambi   +2 more
wiley   +1 more source

Characterization of Aluminized Layers on Inconel‐738 Alloy: Microstructure, Modeling of Aluminizing Kinetics, and Thermal Behavior

Advanced Engineering Materials, EarlyView.
This study explored how effective nickel aluminide coatings are obtained in providing oxidation resistance applied to the Inconel 738 alloy, modeling with diffusion models. In the present study, kinetics and thermal behavior of the Inconel 738 alloy were studied by the low‐temperature thermoreactive aluminizing process, which was carried out at 625°C ...
Gozde Celebi Efe, Tuba Yener, Suayb Cagri Yener, Mourad Keddam, Cuma Bindal   +4 more
wiley   +1 more source

Impact of Auxiliary Equipments’ Consumption on Electricity Generation Cost in Selected Power Plants of Pakistan

Mehran University Research Journal of Engineering and Technology, 2017
This study focuses on higher generation cost of electricity in selected TPPs (Thermal Power Plants) in Sindh, Pakistan. It also investigates the energy consumed by the auxiliary equipment of the selected TPPs in Sindh, Pakistan. The AC (Auxiliary Consumption) of selected TPPs is compared with that in UK and other developed countries.
Dileep Kumar, Rizwan Ahmed Memon, Abdul Ghafoor Memon, Intizar Ali Tunio, Awais Junejo   +4 more
openaire   +3 more sources

Automated Selective Dismantling System for Waste Electrical And Electronic Equipment Recycling

, 2022
With ever-increasing technological advancements, there has been an increase in Waste from Electrical and Electronic Equipment (WEEE). The WEEE keeps on piling every day in tons and won't stop in the future unless specific measures are taken for recycling them. Considering the methods used for recycling in the current recycling organizations the chances
Hemswaroop Raorane, Ashutosh Ambetkar, Shrikant Salaskar, Parth Chaphekar, Shrikant Baste, Dr. Sunil Bobade   +5 more
openaire   +2 more sources

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Comportamentul factorilor de influenţă asupra fiabilităţii sistemelor de distribuţie a energiei electrice

Agricultural Science, 2012
The problems connected to the optimization of reliability in the electrical networks of different voltage levels have a probabilistic character and depend on a number of definite and indefinite factors which have a significant importance in the selection
POPESCU Victor
doaj  

Integration of digital technologies into the design process of power supply systems for mining enterprises

Горные науки и технологии
The study focuses on the development of an integrated software solution for the automation of power supply system (PSS) design for industrial enterprises. The relevance of this work arises from systemic issues observed in existing software packages, such
V. L. Petrov, E. K. Burmatova, A. V. Pichuev   +2 more
doaj   +1 more source

Research on Electrical Application Technology of Intensive Offshore Converter Station

南方能源建设, 2021
[Introduction] Large capacity wind turbines and 66 kV power collection system will be selected for deep sea large-scale offshore wind power transmission.
LIU Sheng
doaj   +1 more source