Results 141 to 150 of about 13,043 (176)

Thermomechanical Assessment of Recovered PA12 Powders with Basalt Filler for Automotive Components. [PDF]

Polymers (Basel)
Napolitano F, Papa I, Cimino F, Lopresto V, Russo P.   +4 more
europepmc   +1 more source

Dimensional Accuracy in 3D Printed Medical Models: A Follow-Up Study on SLA and SLS Technology. [PDF]

J Clin Med
Msallem B, Vavrina JJ, Beyer M, Halbeisen FS, Lauer G, Dragu A, Thieringer FM.   +6 more
europepmc   +1 more source

Progress in Additive Manufacturing of High-Entropy Alloys. [PDF]

Materials (Basel)
Chen B.
europepmc   +1 more source

Systematic Review of the Quality of Stereolithographic Three-Dimensionally Printed Materials for Provisional Dental Restorations. [PDF]

Materials (Basel)
Danila AI, Breban-Schwarzkopf D, Daescu E, Olariu I, Dinu S.   +4 more
europepmc   +1 more source

Optimization of Mechanical Properties and Evaluation of Fatigue Behavior of Selective Laser Sintered Polyamide-12 Components. [PDF]

Polymers (Basel)
Sommer D, Stockfleet H, Hellmann R.
europepmc   +1 more source

Biomaterials-based approaches to mandibular tissue engineering: where we were, where we are, where we are going. [PDF]

Regen Biomater
Kennedy MM, Mikos AG.
europepmc   +1 more source

Three-Dimensional Printing Technology in Drug Design and Development: Feasibility, Challenges, and Potential Applications. [PDF]

J Pers Med
Simon MC, Laios K, Nikolakakis I, Papaioannou TG.   +3 more
europepmc   +1 more source

A Systematic Review of the Contribution of Additive Manufacturing toward Orthopedic Applications. [PDF]

ACS Omega
Joseph A, Uthirapathy V.
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Selective laser sintering (SLS)-printable thermosetting resins via controlled conversion

MRS Communications, 2021
An alternative strategy toward SLS-printable thermosets is demonstrated based on partial curing of the material to increase the Tg of the resin and minimize the additional cure needed to cross-link the printed article. This material is then printed, yet it does not become cross-linked during the printing process.
Mathew Celina, Estevan Martinez, Dominik Jordon Astorga, C. Garrett Campbell   +3 more
openaire   +2 more sources

Fatigue Reliability of Selective Laser Sintered (SLS) Components Using Weibull Analysis [PDF]

Applied Mechanics and Materials, 2012
Selective laser sintered metallic specimens were tested for fatigue cycles to failure and analyzed for reliability. In this study, Taguchi’s experimental techniques were used to develop a modified L9 orthogonal array. Three different process parameters, laser power, scan spacing and slice thickness were selected for manufacturing the components ...
C.D. Naiju, K. Annamalai, S. Karthik, Ramaraj Goutham   +3 more
openaire   +1 more source