Results 181 to 190 of about 952,551 (308)

FIB/SEM Characterization of Paper Materials

, 2016
3D microscopy is of interest for structural characterization of paper materials to study the use of cellulose nanofibrils as a paper additive. Focused ion beam (FIB) tomography is a promising microscopy technique for this application, combining scanning electron microscopy (SEM) with serial sectioning by ion beam, potentially with nanoscale resolution.
openaire   +1 more source

On‐Demand Activation of Thin Alginate Shell Encapsulated Volatile Liquid for Untethered Pneumatic Soft Actuation

Advanced Engineering Materials, EarlyView.
Phase‐changing liquids enable untethered pneumatic actuation in soft robotics but suffer from volatility and storage challenges. This work reports a simple method to encapsulate Novec 7000 within micron‐thin alginate shells via in situ injection and ionic crosslinking.
Rayan A. M. Basodan, Jack Keddie, Byoungyoul Park, Hyun‐Joong Chung   +3 more
wiley   +1 more source

Cell-Type-Dependent Metabolic Compensation Preserves Photoreceptor Survival Through Pyruvate Kinase Isoform Balance. [PDF]

FASEB J
Rajala A, Trevino LJ, Black TM, Rajala RVS.   +3 more
europepmc   +1 more source

Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V

Advanced Engineering Materials, EarlyView.
Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena, Benjamin Bergmann, Michael Zenger   +2 more
wiley   +1 more source

Correction: Effect of multiple calcination cycles on CO₂ capture efficiency during carbonation of MgO in a mineral looping process. [PDF]

Sci Rep
Tajuelo Rodriguez E, Anovitz LM, Adapa S, Yuan K, Hensley D, Chung DY, Boebinger MG, Stack AG, Weber J.   +8 more
europepmc   +1 more source

Population of Nonmetallic Inclusions in Liquid High‐Silicon Electrical Steel in Contact With MgO–C Refractories Based on Recyclates and Environmentally Friendly Binders

Advanced Engineering Materials, EarlyView.
The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert, Matheus Roberto Bellé, Florian Kerber, Dinesh Kumar Gunasekar, Hans‐Jörn Weddige, Christos G. Aneziris, Olena Volkova   +6 more
wiley   +1 more source

Cooling artifacts in ex-situ pore characterization of thermally stimulated low-maturity shale: an in-situ SEM imaging reassessment. [PDF]

Sci Rep
Cheng L, Xu X, Gou J, Liu C, Han K, Jiang C, Liu N, Meng C, Liu J.   +8 more
europepmc   +1 more source

Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys

Advanced Engineering Materials, EarlyView.
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa, Aparna Saksena, Alesander Kostka, Pascal Thome, Felicitas Scholz, Alexandre Mussi, Christoph Somsen, Baptiste Gault, Jan Frenzel, Gunther Eggeler   +9 more
wiley   +1 more source

High Resolution Imaging of Nonequilibrium Colloidal Self-Assembly via Photofixation. [PDF]

ACS Nano
Satpathy J, Chen JJ, Wen G, Masuhara H, Seth S, Leen V, Rocha S, Hofkens J, Louis B, Bresolí-Obach R.   +9 more
europepmc   +1 more source

Corrosion and Process Analysis of a Preoxidized MgO Recyclate‐Based Cermet Anode in Laboratory‐Scale Na‐Cryolite Molten Salt Electrolysis of Aluminum at 1000°C

Advanced Engineering Materials, EarlyView.
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk, Farhan Hossain, Felipe A. Garcia Paz, Serhii Yaroshevskyi, Felix Drechsler, Daniel Vogt, Christos G. Aneziris, Alexandros Charitos   +7 more
wiley   +1 more source