Results 201 to 210 of about 12,716 (259)
Some of the next articles are maybe not open access.

A Design Model for Semi-Rigid Connections

Engineering Structures, 1990
Abstract A three-parameter exponential model is proposed to represent the behaviour of top- and seat-angles with or without double web-angle connections. Two of the parameters, the initial stiffness and the mechanism moment, are theoretically defined and extensively compared with those measured from connection test curves.
Wai-Fah Chen
exaly   +2 more sources

Behavior of Semi-rigid Composite Connections

Engineering Journal, 1987
The 1978 AISC Specification allows three types of framing. Type 1 is for fully rigid moment connections, Type 2 is for pinned connections (although the moment capacity inherent in these connections is recognized and assumed to act in resistance of wind loads), and Type 3 is for semi-rigid connections.
Douglas Ammerman, Roberto T. Leon
openaire   +1 more source

Effect of semi-rigid connections on steel column strength

Journal of Constructional Steel Research, 1980
Abstract A review has been made of all available experimental data relating to the moment versus in-plane rotational behaviour of practical beam-to-column connection types as used in steel frames. This has clearly shown that all forms of connection possess some stiffness which will act as partial restraint to the column's ends.
S.W. Jones, P.A. Kirby, D.A. Nethercot
openaire   +1 more source

Unbraced Frames with Semi-Rigid Composite Connections

Engineering Journal, 1990
The benefits of semi-rigid connections are well known and much has been written about their use in braced frames and in Type 2 construction. One of the reasons these methods are not being used frequently by designers is that most semi-rigid connections are highly nonlinear, and analysis of the behavior of frames using them is difficult.
Douglas Ammerman, Roberto T. Leon
openaire   +1 more source

Formulas for Beams with Semi-rigid Connections

Engineering Journal, 1996
This paper presents practical formulas for beams with semi-rigid connections of variable stiffness, and describes certain limitations for application of these formulas. Using the tables of formulas, the engineer is able to rapidly determine the effect of a partially restrained connection. A practical example illustrates the application of the formulas.
openaire   +1 more source

The study of welded semi‐rigid connections in fire

The Structural Design of Tall and Special Buildings, 2011
SUMMARYConsidering the deterioration of steel properties by temperature increase and the importance of the influence of connection behavior on the behavior of steel structures, we find that the exact understanding of the behavior of a specific steel connection in fire as well as the information about the effect of fire on the principal constitutive ...
Mahmood Yahyai, Amir Saedi Daryan
openaire   +1 more source

Energy Dissipation Characteristics of Semi-Rigid Connections

Journal of Constructional Steel Research, 2009
Abstract This study presents the energy dissipation characteristics of semi-rigid connections obtained from 48 full-scale cyclic tests. The energy calculation was performed on the hysteresis loops obtained from the experimental data in which the area under the outer loop of each hysteresis was calculated.
Mehdi Ghassemieh   +2 more
exaly   +2 more sources

Home - About - Disclaimer - Privacy