Results 171 to 180 of about 81,196 (301)
Advances in Modelling Radiative Transfer, Heat Storage and Turbulent Transport to Evaluate CO<sub>2</sub>, Heat and Water Fluxes Over Broad-Leaved Forests: The CanVeg2 Model. [PDF]
Béland M +5 more
europepmc +1 more source
Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Assessing inter-sensor variability and sensible heat flux derivation accuracy for a large aperture scintillometer. [PDF]
Rambikur EH, Chávez JL.
europepmc +1 more source
Nickel‐based alloys are widely used in high‐temperature applications due to their excellent mechanical strength and oxidation resistance. However, properties such as high‐temperature strength and pronounced work‐hardening make them difficult to machine.
Soheil Rooein +2 more
wiley +1 more source
Evaporative cooling exceeded albedo-induced warming in greening areas of global drylands. [PDF]
Daramola MT, Li R, Xu M.
europepmc +1 more source
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Characterization of the Surface Energy Balance Residual in Complex Terrain. [PDF]
Destro M, Rotach MW, Lehner M.
europepmc +1 more source
The presented study focuses on the fracture behaviour of carbon‐bonded magnesia MgO–C refractories, where environmentally friendly fructose, collagen and lignin serve as temporary binding agents. The partial substitution of the source material with recycled MgO–C reduces the fracture resistance, which can be counteracted by the additional introduction ...
Marc Neumann +6 more
wiley +1 more source
Revisiting the Convective Like Boundary Layer Assumption in the Urban Option of AERMOD. [PDF]
Retter J +5 more
europepmc +1 more source
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source

