Results 11 to 20 of about 58,076 (334)
Control of Tensile Stress in Prestressed Concrete Members Under Service Loads
In current design codes, crack control design criterion for prestressed concrete (PSC) members is stricter than conventional reinforced concrete (RC) members.
Deuck Hang Lee +3 more
doaj +1 more source
CA-Chitosan effect on the time dependent serviceability of jute geotextile under unpaved roads
Biodegradable jute geotextiles (JGTs) are an effective reinforcing material for unpaved roads, but its serviceability is limited because of faster microbial degradation. Different methods are in use to improve the serviceability of jute geotextiles.
Shubham Joshi, Vinay Kumar Midha
doaj +1 more source
The Design of a semi-prefabricated LVL-concrete composite floor [PDF]
This paper describes the design of a novel semi-prefabricated LVL-concrete composite floor that has been developed in New Zealand. In this solution, the floor units made from LVL joists and plywood are prefabricated in the factory and transported to the ...
Fragiacomo, Massimo, Yeoh, David
core +3 more sources
This paper proposes a novel approach to analyze potential accessibility to ambulance services by combining the demand-covered-ratio and potential serviceability with the ambulance-covering-ratio.
EunSu Lee
doaj +1 more source
Study of the effectiveness of outrigger system for high-rise composite buildings for cyclonic region [PDF]
The demands of taller structures are becoming imperative almost everywhere in the world in addition to the challenges of material and labor cost, project time line etc.
Fatima, Tabassum +2 more
core +2 more sources
The load bearing capacity of railway masonry arch bridges [PDF]
This paper deals with the way of calculating the load-bearing capacity of masonry arch railway bridges. It reviews the basic aspects of structural behaviour of these bridges, such as material non-linearity of masonry and interaction with the soil ...
Drahorád, Michal, Vokál, Marek
core +1 more source
Flexural Performance of Reinforced Concrete Members with Steel Bars
The use of high-tension bars to strengthen flexural members is gaining increasing interest. However, the applicability of current standards to such bars is uncertain, because there may not be a definite yield strength and it may be unclear whether the ...
Myunghwan Lim, Changhee Lee
doaj +1 more source
Vibrational Modal Frequencies and Shapes of Two-Span Continuous Timber Flooring Systems [PDF]
Based on classic vibrational bending theory on beams, this paper provides comprehensive analytical formulae for dynamic characteristics of two equal span continuous timber flooring systems, including frequency equations, modal frequencies, and modal ...
Kilpatrick, Tony, Zhang, Binsheng
core +1 more source
Current codes and guidelines for the dynamic design of footbridges often only specify the pedestrian-induced excitations. However, earthquakes may occur during the passing stage of pedestrians in earthquake-prone regions.
Xinxin Wei, Bo Fu, Wenyan Wu, Xinrui Liu
doaj +1 more source
Modeling of the process of time change in quantitative indicators of transmission reliability of multi-axle wheeled chassis at the design stage [PDF]
Multi-axle wheeled chassis are widely used to solve various transport and logistics tasks in areas with difficult terrain, unfavorable soil conditions, the presence of natural obstacles and the lack of minimum necessary transport infrastructure.
Tarichko V.I. +2 more
doaj +1 more source

