Results 1 to 10 of about 173 (164)

Method of Limiting Shaft Voltages in AC Electric Machines

open access: yesEnergies, 2021
The article presents a new method of counteracting shaft voltages and currents in AC electrical machines. It is based on the use of an auxiliary winding located in the stator of the machine.
Sebastian Berhausen, Tomasz Jarek
exaly   +3 more sources

A Comprehensive Review of Shaft Voltages and Bearing Currents, Measurements and Monitoring Systems in Large Turbogenerators

open access: yesEnergies
Turbine generators are essential for power generation, but the presence of shaft voltages and currents poses significant challenges to their reliability, efficiency, and operational lifespan.
Akshay Kumar Saha
exaly   +3 more sources

Research of the Electric Drive with Intermittent Motion Law [PDF]

open access: yesОмский научный вестник, 2020
An electric drive with an intermittent law of the shaft motion of the executive motor, which is widely used in various fields of industry, is considered.
N. A. Voronina   +3 more
doaj   +1 more source

Turboset shaft voltage [PDF]

open access: yesZbornik Radova: Elektrotehnički Institut "Nikola Tesla", 2016
The paper presents an analyses of shaft voltage and bearing current phenomena in electrical machines. An overview of the causes of these voltages and currents and their possible consequences is also given. The influence of the thyristor excitation system
Klasnić Ilija   +2 more
doaj   +1 more source

PENGARUH JARAK MISALIGNMENT DRIVE SHAFT COOLING TOWER TERHADAP TEGANGAN NORMAL DAN TEGANGAN GESER

open access: yesRekayasa Mesin, 2022
The purpose of this study was to determine the effect of misalignment distance of Cooling Tower drive shaft on normal stress and shear stress. Tensions that occur on the shaft continuously for a long time cause the shaft to experience fatigue.
Rachmat Subagyo   +4 more
doaj   +1 more source

Novel Characterization of Si- and SiC-Based PWM Inverter Bearing Currents Using Probability Density Functions

open access: yesEnergies, 2022
The high frequency PWM voltage pulses from a two-level six-switch inverter produce a common-mode voltage in an electric machine’s windings, a fraction of which appears on the machine shaft due to electrostatic (capacitive) coupling.
Ryan Collin   +2 more
doaj   +1 more source

A Power Quality Assessment of Electric Submersible Pumps Fed by Variable Frequency Drives under Normal and Failure Modes

open access: yesEnergies, 2023
This paper proposed a simplified modeling approach for a power quality (PQ) assessment of Electric Submersible Pumps (ESP) systems supplied by the two-level, the neutral-point-clamped three-level, and the cascaded H-bridge (CHB) multilevel inverter VFD ...
Pascal M. Lingom   +4 more
doaj   +1 more source

Application of Perovskite Layer to Rotor for Enhanced Stator-Rotor Capacitance for PMSM Shaft Voltage Reduction

open access: yesEnergies, 2020
Adjustable speed drives use Pulse Width Modulation (PWM) to switch DC-bus voltage for the synthesis of three-phase voltages to provide power to the permanent magnet synchronous motor (PMSM).
Muhammad Aqil, Jun-Hyuk Im, Jin Hur
doaj   +1 more source

Harmonic-Separation-Based Direct Extraction and Compensation of Inverter Nonlinearity for State Observation Control of PMSM

open access: yesIEEE Access, 2021
Nonideal switching characteristics of voltage source inverter (VSI) will result in distortions in both phase currents and reference voltages of a permanent magnet synchronous machine (PMSM) drive system, which will also consequently introduce ripples ...
Shichao Zhou   +7 more
doaj   +1 more source

A Simple Analytical Model of Static Eccentricity for PM Brushless Motors and Validation through FEM Analysis

open access: yesEnergies, 2020
The paper firstly summarizes a simple analytical model of the air gap flux-density distribution for isotropic permanent magnet (PM) synchronous machines, in the presence of static eccentricity.
Andrea Del Pizzo   +2 more
doaj   +1 more source

Home - About - Disclaimer - Privacy