Results 91 to 100 of about 55,764 (261)
A dynamically actuated reconfigurable topographical surface (DARTS) integrates contact‐mediated bactericidal nanotopography with programmable mechanical actuation to actively disrupt bacterial biofilms. Dynamic surface reconfiguration enhances bacterial killing and suppresses implant‐associated infections in vivo, providing a new strategy for active ...
Mohammad Asadi Tokmedash +4 more
wiley +1 more source
An integrated pulmonary mRNA delivery platform combining novel biodegradable syringic acid‐derived ionizable lipids, design‐of‐experiments formulation optimization, and vibrating‐mesh nebulizer engineering enabled stable aerosolization and efficient lung delivery.
Neha Kaushal +21 more
wiley +1 more source
Mass-timber rocking-wall systems are designed to limit residual deformation by concentrating lateral response in controlled uplift, recentering, and replaceable energy-dissipation mechanisms.
Lin Ma +3 more
doaj +1 more source
Genetically Programmed Shape‐Morphing of Engineered Living Materials
Here, bacterial and mammalian engineered living materials (ELMs) are presented, in which living cells direct genetically programmed and enzymatically mediated shape‐morphing. The resulting deformation and shape‐recovery can be actuated in a genetically controlled manner by an ELM incorporating out‐of‐equilibrium counteracting biochemical reactions with
Jan Becker +7 more
wiley +1 more source
Nitride MXenes remain constrained by a persistent gap between computational prediction and experimental realization. This Review identifies the thermodynamic, kinetic, and chemical barriers limiting their synthesis, critically evaluates emerging fabrication routes, and proposes a multidimensional computational‐experimental framework to accelerate the ...
Naresh Varnakavi, Masoud Soroush
wiley +1 more source
Biodegradable 3D‐Printable and Coatable Antifouling Composites for Marine Applications
Marine biofouling damages submerged surfaces and raises greenhouse gas emissions. Biodegradable antifouling biocomposites were developed by hot‐mixing beeswax, Tween 80, and calcium stearate or stearic acid. Adjusting the component ratio enables processing via hot‐pressing, 3D‐printing, or dip‐coating.
Gabriele Corigliano +17 more
wiley +1 more source
Development of a Low-Cost Open-Architecture 2-DOF Shake Table: Design, Modeling, and Control
This paper presents the mechatronic design, mathematical modeling, parameter identification, and nonlinear position control of an open-architecture biaxial shake table capable of generating base acceleration along two orthogonal horizontal directions ...
Diego Armando Ramírez-Zúñiga +5 more
doaj +1 more source
Molecularly Dissipative Liquid Crystal Elastomer Foams for Impact and Vibration Attenuation
Liquid crystal elastomer foams integrate cellular deformation with mesogen reorientation to create a dual‐scale energy dissipation mechanism. Progressive pore collapse absorbs mechanical loads, while stress‐induced mesogen reorientation provides additional damping, resulting in reduced impact transmission and broadband suppression of vibrational ...
Subi Choi +5 more
wiley +1 more source
This data paper presents data obtained from E‐Defense shake‐table tests of a full‐scale, steel moment‐resisting frame (MRF) supplemented with Spines. Herein, the Spines were pin‐based columns with sufficient stiffness and strength to distribute plastic ...
Yi Qie +11 more
doaj +1 more source
Phase transitions are central for the assembly of recombinant silk proteins into fibers. Soluble protein can transition into condensed states such as condensates and gels. These states are metastable and evolve in a time‐dependent way. Metastability depends on the protein sequence, and this relationship can be used to enhance the mechanical properties ...
Fred‐Eric Sammalisto +5 more
wiley +1 more source

