Results 101 to 110 of about 28,584,470 (343)
Additive manufacturing introduces pronounced microstructural and crystallographic anisotropy in Ni‐based superalloys, resulting in orientation‐dependent creep deformation and damage. This review identifies the key microstructural origins of creep anisotropy, examines their influence on dominant deformation mechanisms, and highlights processing ...
Chandan Kumar +3 more
wiley +1 more source
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika +5 more
wiley +1 more source
Shear capacity of reinforced concrete beams using neural network [PDF]
NoOptimum multi-layered feed-forward neural network (NN) models using a resilient back-propagation algorithm and early stopping technique are built to predict the shear capacity of reinforced concrete deep and slender beams.
Song, J-K. +2 more
core +3 more sources
Fiber Model based Nonlinear Shear Effect Modeling Method and Its Calibration
:The disadvantage of conventional fiber model is its neglect of the nonlinear shear effect, and it is difficult to simulate the nonlinear response of the shear wall and other similar components with fiber model.
Yang Hong
doaj
The shear strength of cemented soil-soil interface is affected by the size effect of experimental sample. With the advancing density of urban underground space and the wide application of grouting reinforcement for adjacent underground structures, the ...
Jie Zhou +7 more
doaj +1 more source
Numerical Shear Tests on the Scale Effect of Rock Joints under CNL and CND Conditions
The scale effect of rock joint shear behavior is an important subject in the field of rock mechanics. There is yet a lack of consensus regarding whether the shear strength of rock joints increases, decreases, or remains unchanged as the joint size ...
Xige Liu, Wancheng Zhu, Lankun Li
doaj +1 more source
Model of Metal Microstructure Evolution Considering Shear Effect and Its Simulation Application in Rolling of Heavy Cylinders. [PDF]
Jiao Y, Dong Z, Liang P, Sun J.
europepmc +1 more source
Microstructural evolution of premium rail steel during flash butt welding (FBW), comparing physically simulated heat‐affected zones with actual weld regions. Thermal cycles induce phase transformations and microstructural heterogeneity that influence weld quality and mechanical performance. These findings provide insights into optimizing FBW parameters
Emmanoelle Cintra da Cunha Araújo +15 more
wiley +1 more source
Particle morphology controls the balance between printability and electrical connectivity in low‐temperature AgCu/Ag metallization pastes. Flake‐shaped AgCu particles form extended low‐resistance contacts, whereas spherical particles favor processability at high metal loading. Fine Ag particles further tune void filling and conductive‐network formation
O. Mhirsi +3 more
wiley +1 more source
Analysis on Shear Lag Effect of Steel Box Girders with Double-Level Cantilever Slab
Double-level bridge decks offer significant economic advantages and simplify traffic management. Over time,double-level cantilever slab box girders have been increasingly utilized in steel bridge construction.
Nanhong DING, Longlong LI, Yuanhai ZHANG
doaj +1 more source

