Results 1 to 10 of about 1,622,252 (341)
Molecular dynamics simulation of shear friction process in tectonically deformed coal
Shear friction is an important deformation process in tectonically deformed coals (TDCs) and is closely related to the dynamic metamorphism of coal. In the current study, we perform a molecular dynamics (MD) simulation of the shear friction process on ...
Hewu Liu, Hewu Liu, Yu Song, Zhigang Du
doaj +2 more sources
We discuss crack propagation along the interface between two dissimilar materials. The crack edge separates two states of the interface, ``stick'' and ``slip''. In the slip region we assume that the shear stress is proportional to the sliding velocity, i.
Brener, Efim A., Marchenko, V. I.
core +2 more sources
Solids Under Extreme Shear: Friction‐Mediated Subsurface Structural Transformations [PDF]
AbstractTribological contacts consume a significant amount of the world's primary energy due to friction and wear in different products from nanoelectromechanical systems to bearings, gears, and engines. The energy is largely dissipated in the material underneath the two surfaces sliding against each other.
Greiner, Christian +2 more
openaire +5 more sources
Shear friction strength of monolithic concrete interfaces [PDF]
YesThis paper presents an integrated model for shear friction strength of monolithic concrete interfaces derived from the upper-bound theorem of concrete plasticity.
Aashto (American Association of State Highway and Transportation Officials) +14 more
core +2 more sources
Experimental study on nonlinear friction behavior of granular flow lubrication
Solid granules have good lubrication performance and load-bearing capacity, which has been concerned by researchers. However, the correlation mechanism between lubrication performance and granular medium dynamics is hardly focused on.
Fanjing Meng +4 more
doaj +1 more source
Experimental study on interfacial friction characteristics of composite geomembranes
The interfacial friction characteristics of composite geomembranes have a significant impact on the stability of engineering structures. To comprehensively analyze the interfacial friction properties of composite geomembranes and cushion materials, the ...
Wu Yang, Kebin Shi, Jianxin He
doaj +1 more source
Friction of Shear-Fracture Zones [PDF]
A shear fracture of brittle solids under compression undergoes a substantial evolution from the initial microcracking to a fully formed powder-filled shear zone. Experiments covering the entire process are relatively easy to conduct, but they are very difficult to investigate in detail. Numerically, the large strain limit has remained a challenge.
Pylväinen, J. I. +3 more
openaire +4 more sources
Shear thickening fluids (STFs) refer to non-Newtonian fluids of the dilatant variety, wherein their viscosity experiences a significant surge with an escalation in the shear rate. In this investigative work, the friction behavior between yarns (pull-out)
Thiago F. Santos +4 more
doaj +1 more source
Relation between interfacial shear and friction force in 2D materials
Understanding the interfacial properties between an atomic layer and its substrate is of key interest at both the fundamental and technological levels.
M. Rejhon +6 more
semanticscholar +1 more source
In composite structures, interface shear resistance is a critical design criterion for transferring forces between interconnected elements at the contact surface.
Mostafa Abo El-Khier, George Morcous
doaj +1 more source

