Results 11 to 20 of about 2,245,510 (271)
Punching shear strength of steel fibre reinforced lightweight concrete slabs. [PDF]
, 1981 One of the problems in slab-column connections is the punching shear failure at over loads. Such failures are sudden and catastrophic, and are undesirable since they do not allow an overall yield mechanism to ...
Theodorakopoulos, Dimitrios D.
core +6 more sources
Experimental studies of scale effects on shear strength, and deformation of rock joints [PDF]
, 1980 The effect of scale on shear strength is studied by performing direct shear tests on different sized samples of large joints. A rubber moulding system is used to obtain impressions of the roughness from a variety of natural joint surfaces.
Bandis, Stavros
core +6 more sources
Shear transfer between precast prestressed bridge beams and in-situ concrete crosshead in continuous structures [PDF]
, 1988 A detailed investigation was made to study the shear transfer between precast prestressed beams and in-situ concrete in a relatively new method of construction of continuous bridge decks where the ends of precast beams are connected to an integral in ...
Mirtalaie, Kamal
core +7 more sources
Shear resistance of reinforced concrete beams with and without steel fibres. [PDF]
, 1981 The fabrication and placement of conventional shear rein- forcement are time consuming and costly and its use in thin structural concrete members is often impractical.
Chiam, Tou Ping
core +6 more sources
Frontiers in Earth Science, 2022 The capillary component and adsorptive component of matric suction differently impact the soil strength. Due to the cavitation effects of pore water, the adsorption effect dominates the behavior of soil when matric suction exceeds the cavitation tension.
Xiaoang Kong +4 more
doaj +1 more source
Frontiers in Earth Science, 2022 The degradation of shear mechanical properties of rock fracture surfaces was determined after applying multiple dry-wet cycles. Artificially fractured feldspathic sandstone specimens were soaked in chemical solutions with pH values of 2, 7, and 12 for 3,
Baohua Guo +7 more
doaj +1 more source
An Advanced Shear Strength Criterion for Rock Discontinuities Considering Size and Low Shear Rate
Applied Sciences, 2020 The shear strength of the rock discontinuities under different shear rates is of great importance to evaluate the stability of rock mass engineering, which is remarkably influenced by the size effects induced by both the length and the undulated ...
Bowen Zheng +6 more
doaj +1 more source
Shear strength properties of hybrid (hinoki cypress and Japanese cedar) cross-laminated timber
Journal of Wood Science, 2021 In this study, the out-of-plane shear strength of hybrid cross-laminated timber (CLT) with outer layers of hinoki (hinoki cypress, Chamaecyparis obtusa) and inner layers of sugi (Japanese cedar, Cryptomeria japonica) is investigated for four different ...
Seiichiro Ukyo +3 more
doaj +1 more source
Continuity development between precast beams using prestressed slabs, and its effect on flexure and shear [PDF]
, 1989 Development of continuity between precast prestressed bridge girders by post-tensioning the insitu top slab In the regions of hogging moment is a relatively new technique which forms the basis for this research study.
Jayanandana, Aluthjage Don Chandrathilaka
core +7 more sources
Improved Shear Strength Equation for Concrete Wide Beams
Applied Sciences, 2019 An improved shear strength equation is proposed that considers transverse reinforcement spacing and support conditions for concrete wide beams. Eighteen specimens were fabricated to examine the influence of transverse reinforcement spacing, the number of
Min Sook Kim +2 more
doaj +1 more source