Results 311 to 320 of about 3,778,187 (402)

Improvement of Solder Joint Shear Strength under Formic Acid Atmosphere at A Low Temperature. [PDF]

Materials (Basel)
He S, Jiang J, Shen YA, Mo L, Bi Y, Wu J, Guo C.   +6 more
europepmc   +1 more source

Effect of Various Etching Techniques on Shear Strength of Newer Generation Composites.

J Pharm Bioallied Sci
Chaudhari WA, Birajdar A, Jani K, Deshmukh MV, Thakar GC, Soni SN.   +5 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

Shear Strength

Encyclopedia of Ocean Engineering, 2020
Xiaodong Chen, Kai-jin Sun
semanticscholar   +2 more sources

Shear strength behaviour and the measurement of shear strength in residual soils [PDF]

, 2012
The selection of appropriate strength parameters and the prediction of deformation and failure are important steps in the design of foundations and cut slopes in residual soils. In countries with widespread residual soils, strength testing practice, both in the laboratory and in the field mostly follows standard procedures, employing triaxial and shear
R.P. Brenner, V.K. Garga G.E. Blight
openaire   +1 more source

Analysis of Shear Strength of Wood

Key Engineering Materials, 2011
This paper presents the analysis of different types of shear strength of wood which can differ very much due to its structure and different orientations of applied load. These combinations of wood structure and load orientations lead to different modes of fracture. The main aim of the paper is to find a relation among all types of shear strength of the
Aleksandar Jurić, Pavao Marović, Tihomir Štefić   +2 more
openaire   +2 more sources

Shear Strength of Rockfill

Journal of the Geotechnical Engineering Division, 1981
A practical method for estimating the shear strength of rockfill is developed. The peak drained friction angle π(prime) is found to be closely related to that of rock joints. In both cases the values of π(prime) are dependent on sample size, stress level, surface roughness, and on the uniaxial compression strength of the rock.
Bjorn Kjaernsli, Nick Barton
openaire   +2 more sources

Shear strength and shear bands of anisotropic sand

Acta Geotechnica, 2021
Due to sedimentation, irregular particles of sand arrange anisotropically in nature. Anisotropy diversifies the internal friction angles between relative research planes at different directions in soil material. Thus, to analyze the mechanical mechanism of strength anisotropy, except for conventional inherent anisotropy of the material, stress ...
Tong Dong, Yingren Zheng, Kong Liang, Chao Liu   +3 more
openaire   +2 more sources

Shear Strength of Montmorillonite

Géotechnique, 1970
Synopsis Artificially sedimented specimens of Wyoming bentonite (Volclay) were used to investigate the effect of physico–chemical variables on the shear strength properties of montmorillonite. Triaxial compression tests were performed on calcium and sodium montmorillonite at various electrolyte concentrations.
Gholamreza Mesri, Roy E. Olson
openaire   +2 more sources

Shear Strength of Ferrocement Beams

ACI Structural Journal, 1987
An experimental investigation was carried out on a total of 28 simply supported ferrocement I-beams loaded in flexure under two symmetrical point loads. The major parameters considered in the study were the shear span-to-depth ratio a/h, compressive strength of the mortar, and amount of longitudinal and transverse reinforcement.
Mansur, M.A., Ong, K.C.G.
openaire   +2 more sources