Granular Flows in Split-Bottom Geometries
, 2010 There is a simple and general experimental protocol to generate slow granular flows that exhibit wide shear zones, qualitatively different from the narrow shear bands that are usually observed in granular materials .
Bordignon +28 more
core +1 more source
Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition
Advanced Engineering Materials, EarlyView.A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley +1 more source
Investigation of Lateral Stress Relief on theStability of PHI = 0 DEG Slopes Using Laboratory, Fracture Mechanics, and Finite Element Method Approaches [PDF]
, 2011 Total stress analyses of purely cohesive cut slopes utilize the undrained shear strength for slope stability analyses. These slopes can have an in-situ lateral earth pressure that is greater than the vertical pressure.
Kutschke, Walter
core
Effect of Laser Deoxidation on Adhesive‐Bonded Aluminum in an Oxygen‐Free Atmosphere
Advanced Engineering Materials, EarlyView.This study investigates laser ablation of aluminum under oxygen‐free conditions. The goal is to produce oxide‐free substrates that enable improved adhesive bonding with epoxy. Optimized laser parameters (90% overlap, 300 µJ) combined with oxide‐free substrates result in the highest tensile strength of the adhesive bond.
Sandra Gerland +5 more
wiley +1 more source
Frontiers in Earth ScienceA series of NE-to E-trending ductile shear zones are widely distributed in the Khondalite Belt, a Paleoproterozoic collisional orogen in the North China Craton.
Hengzhong Qiao +3 more
doaj +1 more source
Strain Localization: Analog Modeling and Anisotropy of Magnetic Susceptibility
Geochemistry, Geophysics, Geosystems, 2023 The majority of the strain in Earth crust and upper mantle is localized to the high strain zones developed at ductile‐to‐brittle condition at kilometer‐to‐micrometer scale.
Zuzana Roxerová +3 more
doaj +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Advanced Engineering Materials, EarlyView.Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Dynamic earthquake rupture preserved in a creeping serpentinite shear zone
Nature Communications, 2018 Creeping serpentinite shear zones may host large earthquakes, but direct evidence of frictional heating and rupture have been missing. Here, the authors demonstrate via laboratory experiments that earthquake ruptures can propagate through serpentinite ...
Matthew S. Tarling +3 more
doaj +1 more source
The older ultramafic rocks of Aberdeenshire, similarities to SSZ ophiolites and significance for regional tectonics [abstract] [PDF]
, 2008 It has long been known that there are at least two phases of mafic-ultramafic magmatism in NE Scotland (Read 1919), the well known Younger Gabbro suite and a lesser known ‘Older suite’.
Styles, Michael
core
Local yield stress statistics in model amorphous solids
, 2018 We develop and extend a method presented in [S. Patinet, D. Vandembroucq, and M. L. Falk, Phys. Rev. Lett., 117, 045501 (2016)] to compute the local yield stresses at the atomic scale in model two-dimensional Lennard-Jones glasses produced via differing ...
Barbot, Armand +6 more
core +2 more sources