Results 81 to 90 of about 2,769,468 (302)
Advanced Engineering Materials, EarlyView.High‐temperature interactions between low‐sulfur Al‐killed Mn–B steel and MgO–C refractories (0 and 50 wt% recyclates) are studied via finger immersion tests (1600 °C). Surface‐active elements influence infiltration. MgO/CaS layer forms, along with spinel and calcium silicate.
Matheus Roberto Bellé +5 more
wiley +1 more source
The physiological aspects of traumatic shock [PDF]
, 1942 Thesis (M.A.)--Boston UniversityThe condition known as shock has been recognized and described by the medical profession for a great many years.
Akers, Robert Preston
core +1 more source
Advanced Engineering Materials, EarlyView.The thermal diffusivity of MgO‐C refractories is highly sensitive to sample preparation and processing procedures. In this article, the effects of coking sequence, machining conditions, structural inhomogeneity, and graphite coating application on measurements using laser flash apparatus are systematically investigated.
Luyao Pan +4 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
On Reflection of Shock Waves from Boundary Layers [PDF]
, 1952 Measurements of the reflection characteristics of shock waves from a flat surface with a laminar and turbulent boundary layer are presented. The investigations were carried out at Mach numbers from about 1.3 to 1.5 and a Reynolds number of 0.9 x 10^4.
Dhawan, S., Liepmann, H. W., Roshko, A.
core +1 more source
Experimental generation of shock‐induced pseudotachylites along lithological interfaces [PDF]
, 2000 T. Kenkmann, U. Hornemann, D. Stöffler
openalex +1 more source
Advanced Functional Materials, EarlyView.Novel ferrocene derivatives (e.g., FcPhc2) are used as an ultrathin layer hole‐blocking layer, reducing hole injection from the Ag contact. This results in an ultralow noise spectral density of 1.2 × 10−14 A Hz−1/2, and a high specific detectivity of 8.1 × 1012 Jones at −0.5 V.
Eunyoung Hong +16 more
wiley +1 more source
Reverse Ballistic Impact Studies of Thin Plate Perforation
Engineering Transactions, 2014 Full-scale ballistic experiments using tungsten rods and rolled homogeneous armour (RHA) steel plates are expensive to perform. For this reason, a study has been performed into the possibility of using less expensive, more easily available metals in ...
L. C. FORDE +4 more
doaj +1 more source
Over‐expression of heat shock factor 1 phenocopies the effect of chronic inhibition of
, 2012 Anson Pierce +7 more
openalex +1 more source
Advanced Functional Materials, EarlyView.Intelligent radiative cooling devices, adaptable to various weather conditions, have the potential for year‐round energy savings. This study introduces a sustainable dual‐mode film made from polycaprolactone nanofibers and upcycled chip bags for effective thermal management.
Qimeng Song +4 more
wiley +1 more source