Results 61 to 70 of about 33,460 (219)
This paper deals with the effect of electrodynamic forces acting on the primary current paths of residual current circuit breakers. This paper consists of a simulation part and an experimental part from the short-circuit tests performed. The experimental
Michał Szulborski +3 more
doaj +1 more source
P4bm framework in NaNbO3‐Ba(Ti, Hf)O3 ferrodistortive relaxor entails short‐range and highly‐polar ferrodistortive orders. The abundant highly‐polar orders facilitate to increase entropy change, and robust octahedral oxygen tilt enables to impede thermal perturbations.
Feng Li +11 more
wiley +1 more source
MICROPROCESSOR-BASED PROTECTION DEVICE ELECTRIC MOTORS AGAINST SHORT CIRCUIT CURRENTS
The microprocessor device of protection of electric chains of electric motors from short circuit currents, in which switching-off of a short circuit current is carried out before it achieves a shock value, is presented.
D. V. Ustymenko
doaj
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo +10 more
wiley +1 more source
A soft, dual‐channel hydrogel patch enables simultaneous detection of wound temperature and strain by integrating ion‐diffusion‐mediated thermoelectric and resistive sensing. The conformal design maintains stable performance during motion, capturing subtle inflammatory and mechanical changes for continuous wound monitoring.
Yu Fang +7 more
wiley +1 more source
Here, we provide the reader with the current state of the art in the fabrication of high‐T2‐coherence diamond, optimized through the use of double electron–electron resonance (DEER) spectroscopy. We reveal the main as well as yet unidentified spin defects, the reduction of which is essential for reducing the spin bath and fabricating materials for ...
Olga Rubinas +6 more
wiley +1 more source
Existing short-circuit calculation methods for distribution networks with renewable energy sources ignore the fluctuation of renewable sources and cannot reflect the impact of renewable sources and load changes on short-circuit current in real time at ...
Dan Liu +5 more
doaj +1 more source
Parameters of DC high-speed circuit-breakers
DC high-speed circuit-breakers (HSCB) are the basic protection to cut off short-circuit and overload currents. People’s and railway infrastructure devices’ safety depend on their reliability and parameters.
Rojek Artur
doaj +1 more source
Fully additive vertical organic electrochemical transistors (vOECTs) with channel‐length of 226 nm on a 50 µm compostable substrate achieve >106 current modulation and ∼36 mS transconductance. Ion‐selective integration enables 1.1 mA dec−1 sensitivity and 36 µm detection limit, highlighting a scalable platform for sustainable electronics and ...
Giulia Frusconi +3 more
wiley +1 more source
Frequency and time fault diagnosis methods of power transformers
The authors describe experimental and theoretical analyses of faults of power transformer winding. Faults were caused by mechanical effect of short-circuit currents. Measurements of transformer were carried out in high-voltage laboratory.
Gutten Miroslav +5 more
doaj +1 more source

